Scribd
Upload
27 views

MD & Cad Ii Lab: Objective

This document provides instructions for an experiment using pattern, extrude, and chamfer commands in MD & CAD II LAB. Students are asked to sketch and extrude shapes on a part file, use rounding and extruding to add features, pattern shapes around a center point, extrude and pattern rectangles inside and around a circle, and save the final designed model.

Uploaded by

Riaz Ahmad
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
27 views

MD & Cad Ii Lab: Objective

This document provides instructions for an experiment using pattern, extrude, and chamfer commands in MD & CAD II LAB. Students are asked to sketch and extrude shapes on a part file, use rounding and extruding to add features, pattern shapes around a center point, extrude and pattern rectangles inside and around a circle, and save the final designed model.

Uploaded by

Riaz Ahmad
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MD & CAD II LAB

EXPERIMENT #05

Objective
Pattern , Extrude and chamfer commands.

Procedure

1. Start a new “part” file.


2. Select the “Front” plane.
3. Select the Sketch icon.
4. Select front face.
5. Draw the sketch according
to shape.
6. Extrude the shape.
7. By using round com-
mand , round all the edges.
8. Select Extrude Com-
mand ,sketch a circle on
the center point then ex-
trude it.
9. On the front plane , on the center

line draw a shape curved from all

sides.

10.Using pattern command to copy

shape about the center point.

11. On the outline of circle , select

sketch on the front plane and draw

a rectangle.

12.Using extrude command , remove

material of rectangle.

13.Using pattern command , repeat the

rectangle on 360 degrees.

14.Save the file.

Result

Designed Model

You might also like