Scribd
Upload
83 views1 page

Commissioning Service Department Commissioning Standard Test Formats Description: ON LOAD TEST - MBC1

This document provides a standard test format for an on load test of a main bus coupler (MBC1) at a substation. The test format includes: 1) General data and information about the bay and equipment under test. 2) Relay settings for the protection scheme. 3) Step-by-step instructions for performing an on load test to verify the protection scheme is operating correctly with the main bus in service.

Uploaded by

Googool Y
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
83 views1 page

Commissioning Service Department Commissioning Standard Test Formats Description: ON LOAD TEST - MBC1

This document provides a standard test format for an on load test of a main bus coupler (MBC1) at a substation. The test format includes: 1) General data and information about the bay and equipment under test. 2) Relay settings for the protection scheme. 3) Step-by-step instructions for performing an on load test to verify the protection scheme is operating correctly with the main bus in service.

Uploaded by

Googool Y
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Commissioning Service Department

Commissioning Standard Test Formats


Description: ON LOAD TEST – MBC1 Record No.:
Bay no.: Drawing ref.: Sheet: 1 of 1
Contractor: Contract no.: Substation No :

1. GENERAL DATA AND INFORMATION:

Bay No. : Aux. Voltage :


Bay Name : Serial No. :
Manufacturer : Order No. :
Drawing and Sh. No. : Conn. Diag. No. :
Type of Stabilizing Resistor: Current Rating :

2. RELAY SETTINGS:
Ks= N= Kt= Rpp=
Pilot loop Resistance:
Stabilizing Resistor Value:
Load MW Import/Export MVAR Import/Export
Local
Remote

3. ON LOAD TEST (TCS-P-105-R1-5.23.2)

- Make the 87PW protection out of service.


- Make the jumper in the MCRI Contact 2 & 4 to enable 87PW protection.
-
Phase Pilot Normal Relay Pilot Reverse Relay
Values
Phase In Disco. Main Local Remote of Ks
Service And Main Local Remote OP RES OP RES
Pilot Relay Relay
Short pilot Relay Relay
L R L R L R L R
R-Y-B-N
R-N
Y-N
B-N
R-Y
Y-B
B-R
R-Y-B-N

- Remove the jumper wire form the MCRI Relay contact 2& 4
- Normalize the CT Circuits
- Normalize all the pilot Circuits
- Put the Protection in to service

Tested by: ENG. Witnessed by: ENG.

Signature & Date: Signature & Date:

You might also like