Mechanical Engineering Mcqs Part 2: Nts Results
Mechanical Engineering Mcqs Part 2: Nts Results
Mechanical Engineering Mcqs Part 2: Nts Results
(e) under some conditions one value and sometimes two values of specific heat.
Ans: b
(a) the molecular weights of all the perfect gases occupy the same volume under same
(b) the sum of partial pressure of mixture of two gases is sum of the two
(c) product of the gas constant and the molecular weight of an ideal gas is constant
Ans: a
(b) does not depend on the mass of the system, like temperature, pressure, etc.
Ans: a
(a) + ve
(b) -ve
(c) zero
(d) maximum
(e) minimum.
Ans: c
40. The statement that molecular weights of all gases occupy the same volume is
known as
Ans: a
41. To convert volumetric analysis to gravimetric analysis, the relative volume of each
Ans: b
42. If a gas is heated against a pressure, keeping the volume constant, then work
(b) – ve
(c) zero
Ans: c
(a) mass does not cross boundaries of the system, though energy may do so
(b) neither mass nor energy crosses the boundaries of the system
(c) both energy and mass cross the boundaries of the system
Ans: b
coordinates are
Ans: b
45. Which of the following quantities is not the property of the system
(a) pressure
(b) temperature
(d) heat
(e) density.
Ans: d
46. According to Avogadro’s law, for a given pressure and temperature, each molecule
of a gas
Ans: e
Ans: d
(b)internal energy
Ans: e
(a) 21
(b) 23
(c) 25
(d) 73
(e) 79.
Ans: b
50. Which of the following is not the intensive property
(a) pressure
(b) temperature
(c) density
(d) heat
Ans: d
(a) heat
(b) work
(d) vdp
Ans: e
52. Work done in an adiabatic process between a given pair of end states depends on
Ans: a
Ans: c
54. Which of the following parameters is constant for a mole for most of the gases at a
given temperature and pressure
(a) enthalpy
(b) volume
(c) mass
(d) entropy
Ans: b
ntsresults.org
Ans: b
(a) one value of specific heat (ft) two values of specific heat
(e) one value under some conditions and two values under other conditions.
Ans: a
57. A perfect gas at 27°C is heated at constant pressure till its volume is double. The
final temperature is
(a) 54°C
(b) 327°C
(c) 108°C
(d) 654°C
(e) 600°C
Ans: b
58. Curve A in Fig. 1.1 compared to curves B and C shows the following type of
expansion
(a) pV”=C
(b) isothermal
(c) adiabatic
(e) throttling.
Ans: b
59. If value of n is infinitely large in a polytropic process pV” = C, then the process is
known as constant
(a) volume
(b) pressure
(c) temperature
(d) enthalpy
(e) entropy.
Ans: a
60. The index of compression n tends to reach ratio of specific heats y when
(d) process is isentropic and specific heat does not change with temperature
Ans: d
http://ntsresults.org/sample-papers-nts/
Ans: a
Ans: c
63. A heat exchange process in which the product of pressure and volume remains
constant is known as
Ans: e
(a) increases
(b) decreases
Ans: c
(c) states that if two systems are both in equilibrium with a third system, they are in
thermal equilibrium with each other
Ans: c
66. If a certain amount of dry ice is mixed with same amount of water at 80°C, the
(a) 80°C
(b) 0°C
(c) 40°C
(d) 20°C
(e) 60°C.
Ans: b
Ans: a
(a) 1 Nm/s
(b) 1 N/mt
(c) 1 Nm/hr
(d) 1 kNm/hr
(e) 1 kNm/mt.
Ans: a
(c) throttling
Ans: d
70. For which of the following substances, the gas laws can be used with minimum
error
Ans: d
71. In a non-flow reversible process for which p = (- 3V+ 15) x 105N/m2,V changes
(e) 10xl04ki\ojoules.
Ans: c
72. The value of the product of molecular weight and the gas characteristic constant
(b) 8314kgfm/mol°K
(c) 848kgfm/mol°K
(d) 427kgfm/mol°K
Ans: c
73. On volume basis, air contains following parts of oxygen
(a) 21
(b) 23
(c) 25
(d) 77
(e) 79.
Ans: a
74. Universal gas constant is defined as equal to product of the molecular weight of the
gas and
(e) unity.
Ans: d
75. The value of the product of molecular weight and the gas characteristic constant
(b) 83.14J/kmol°K
(c) 848J/kmol°K
Ans: b
76. For which of the following substances, the internal energy and enthalpy are the
(c) water
Ans: d
Ans: c
78. If a gas vapour is allowed to expand through a very minute aperture, then such a process is
known as
(e) throttling.
Ans: e
(a) temperature
(b) pressure
Ans: a
80. If a fluid expands suddenly into vacuum through an orifice of large dimension, then
(e) throttling.
Ans: a
(a) throttling
Ans: e
(a) isothermal
(b) adiabatic
(c) throttling
Ans: c
encountered
(b) when heat is being absorbed, temperature of hot source and working sub¬stance
should be same
(c) when beat is being rejected, temperature of cold source and working sub-stance
should be same
Ans: d
84. For a thermodynamic process to be reversible, the temperature difference between
(a) zero
(b) minimum
(d) maximum
(d) infinity
Ans: a
85. Minimum work in compressor is possible when the value of adiabatic index n is
equal to
(a) 0.75
(b) 1
(c) 1.27
(d) 1.35
(e) 2.
Ans: b
86. Molecular volume of any perfect gas at 600 x 103 N/m2 and 27°C will be
(a) 4.17m3/kgmol
(e) 417m3/kgmol.
Ans: a
original volume. During the process 300 kJ heat left the gas and internal energy
(a) 300 Nm
(b) 300,000 Nm
(c) 30 Nm
(d) 3000 Nm
Ans: b
Ans: d
Ans: a
(a) maximum
(b) minimum
(c) zero
(d) unpredictable
(e) negative.
Ans: c
Ans: c
(c) internal energy, enthalpy and entropy during a process remain constant
Ans: d
93. Energy can neither be created nor destroyed but can be converted from one form
Ans: b
Ans: b
95. Change in enthalpy in a closed system is equal to heat transferred if the reversible
(a) pressure
(b) temperature
(c) volume
(d) internal energy
(e) entropy.
Ans: a
(a) increases
(b) decreases
Ans: c
97. Change in internal energy in a closed system is equal to heat transferred if the
(a) pressure
(b) temperature
(c) volume
(e) entropy.
Ans: c
Ans: c
(b) entropy
Ans: d
(b) does not help to predict whether the system will or not undergo a change
Ans: e
Ans: d
Ans: a
Ans: b
Ans: d
Ans: b
(a) 650°K
(b) 600°K
(c) 625°K
(d) 700°K
(e) 750°K.
Ans: a
(a) temperature
(b) enthalpy
Click on the Link below to view all nts papers