Scribd
Upload
82 views2 pages

Attachment

The document contains 5 questions regarding motor drives and their parameters such as inertia, torque, efficiency, and speed. Each question provides specific values for these parameters and asks the reader to calculate related values such as equivalent inertia, power, equilibrium speeds, or flywheel moment of inertia.

Uploaded by

BRAJESH KUMAR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
82 views2 pages

Attachment

The document contains 5 questions regarding motor drives and their parameters such as inertia, torque, efficiency, and speed. Each question provides specific values for these parameters and asks the reader to calculate related values such as equivalent inertia, power, equilibrium speeds, or flywheel moment of inertia.

Uploaded by

BRAJESH KUMAR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
You are on page 1/ 2

Q.1 A motor drives two loads. One has rotational motion.

It is coupled to the motor through a reduction


gear with a = 0.1 and efficiency of 90%. The load has a moment of inertia of 10 kg-m2 and a torque of 10
N-m. Other load has translational motion and consists of 1000kg weight to be lifted up at an uniform
speed of 1.5m/s. Coupling between this load and the motor has an efficiency of 85% . Motor has an
inertia of 0.2kg-m2 and runs at a constant speed of 1420rpm. Determine equivalent inertia referred to the
motor shaft and power developed by the motor.

Q.2 A drive has following parameters:

T = 150 – 0.1N, N-m and load torque is 𝑇𝑙 = 100 N-m, Initially the drive is operating in steady state.
The characteristic of the load torque are changed to 𝑇𝑙 = −100 N-m. Calculate initial and final
equilibrium speeds. Where N is speed in rpm.

Q.3 A drive has following parameters:

J = 10 kg-𝑚2 , T = 100 – 0.1N (N-m), Passive load torque 𝑇𝑙 = 0.05𝑁 (N − m) Where N is speed in
rpm. Initially the drive is operating in steady state. Now it is to be reversed. For this motor characteristic
is changed to 𝑇𝑙 = − 100 – 0.1N . Calculate the time reversal.

Q.4 A motor equipped with a flywheel is to supply a load torque of 600 N-m for 10 sec followed by a no
load period long enough for the flywheel to regain its steady state speed. It is desired to limit the motor
torque to 450 N-m. What should be the moment of inertia of flywheel? Its no load speed is 600rpm and
the slip at a torque of 400 N-m is 8%. Motor has an inertia of 10 kg-𝑚2 . Assume speed torque
characteristic of motor to be a straight line in the region of interest.

Q.5 A drive has following equation for motor and load

𝑇𝑚 = 1 + 2𝑤𝑚 and 𝑇𝑙 = 3√𝑤𝑚

Obtain the equilibrium point speed.

You might also like