Scribd
Upload
86 views7 pages

NX-OS Unicast & Multicast Routing Review

Overview of unicast and multicast routing DCV2

Uploaded by

Damilola Adebolu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
86 views7 pages

NX-OS Unicast & Multicast Routing Review

Overview of unicast and multicast routing DCV2

Uploaded by

Damilola Adebolu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

NX-OS Unicast &

Multicast Routing Review


DCv1 vs. DCv2 Routing Scope
» DCv1
• Implement Basic EIGRP in Data Center Environment
• Implement Basic OSPF in Data Center Environment
» DCv2
• Design, Implement and Troubleshoot Complex Layer 3 Technologies
• Design, Implement and Troubleshoot Routing Protocols and features for
example OSPF, ISIS, MBGP, IBGP, PBR, BFD
• Design, Implement and Troubleshoot Multicast protocols for example PIM,
IGMP, RP, BSR
» Why the change?
• Underlay Unicast & Multicast routing is required for overlay tunnels
• E.g. OTV, LISP, VxLAN, etc.

Copyright © www.ine.com
NX-OS Unicast Routing Review
» Do you know unicast routing on IOS?
• Cisco Nexus 7000 NX-OS/IOS Comparison Tech Notes
» NX-OS routing logic stays the same
• Enable the protocol
• Discover routing peers
• Form routing adjacencies
• Exchange routing information
• Calculate routing topology
• Install forwarding results in the RIB/FIB
Copyright © www.ine.com
Unicast Routing Verification & Troubleshooting

» What are the common problems in this workflow?


• How do I check if the protocol is on?
• How do I check protocol adjacencies?
• What would prevent a protocol adjacency?
• How do I check routing exchange?
• What would prevent routing exchange?
• How do I verify path selection?
• How can I modify path selection?

Copyright © www.ine.com
NX-OS Multicast Routing Review
» Do you know multicast routing on IOS?
• Cisco NX-OS/IOS Multicast Comparison
» NX-OS multicast logic stays the same
• Enable the protocol
• Establish PIM adjacencies
• Discover the RP(s)
• Discover the sender(s)
• Discover the receiver(s)
• Build the (*,G) or (S,G) tree
Copyright © www.ine.com
Multicast Routing Verification & Troubleshooting

» What are the common problems in this workflow?


• How do I check if the protocol is on?
• How do I check protocol adjacencies?
• What would prevent a protocol adjacency?
• How do I check the RP information?
• How do I verify the senders?
• How do I verify the receivers?
• How do I verify the end-to-end trees?
• How can I modify path selection?
Copyright © www.ine.com
Q&A

Copyright © www.ine.com All rights reserved.

You might also like