Scribd
Upload
2K views7 pages

DSP NK105 Operating Instruction DSP Control System DSP Operate Manual

1. Install the machine parts and DSP control box. Connect the power lines with blue to zero, red to fire. 2. Open the power switch. The green button is for switching, red is an emergency stop. 3. The DSP screen buttons control functions like feed rate, spindle gear, axis movement, and switching between manual and coordinate systems.

Uploaded by

Md. Atiqur Rahman Talukdar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views7 pages

DSP NK105 Operating Instruction DSP Control System DSP Operate Manual

1. Install the machine parts and DSP control box. Connect the power lines with blue to zero, red to fire. 2. Open the power switch. The green button is for switching, red is an emergency stop. 3. The DSP screen buttons control functions like feed rate, spindle gear, axis movement, and switching between manual and coordinate systems.

Uploaded by

Md. Atiqur Rahman Talukdar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

1.

First , after receive your machine ,check your parts box , if have any problem ,please contact
us.
2. Install machine :machine most already contact good,.you only need install DSP to control
box,so picture:

3. Install voltage 380V : Blue line ----zero line Red line -----fire wire
4. After install complete ,open power switch . Green ---switch button Red ------scram button

5. DSP screen button function

point button : Increase feedrate shift+7 : Increase spindle gear

point button:Decrease feedrate shift+1 : Decrease spindle gear

point button:Spindle start/stop shift+5 : Backing to workpiece origin


point button:Y+ moving shift+8 :Switch between workpiece
coordinate and mechanical coordinate

point button:Y - moving

point button:Z+ moving

point button:Z- moving

point button:X- moving shift+4 : Backing to mechanical origin

point button:X+ moving

point button: Switch between manual high/low speed


point button: X Y axis zero clearing (confirm X Y workpiece origin)
shift+(z=0) : Z axis zero clearing

point button:Menu shift+ : Entering help page

point button:start shift+ :Breakpoint resuming

point button: Suspend processing ; up direction key

point button:Stop processing; cancellation of various selections, inputs and


operations

Auxiliary key continuous and step of switching


point button: down direction key

point button:Entering manual high/low speed adjustment page under menu


page; confirmation of various selections, inputs and operations
6. System Start-up

Point : Machine Z X Y backing to mechanical origin.

First time you can point ,check relevant parameter.


Main parameter :

point button enter, choose 5 (Manufacturers parameters) ,Enter Password (33587550)


enter , 3 (pulse equivalent) X :0.0098125 Y : 0.0098125 Z: 0.00625 4 (Machine travel) upper
limit : X 1300 Y 2500 Z0 lower limit: X 0 Y 0 Z --200
Speed Parameter :

point button enter, choose 4 (Operator parameters) 1 is Traveling speed 2 is working


speed.
Load the file

install U disk, point button

enter ,choose 2 (Browse U disk file) 1.load

2.delete 3. Copy

. First point 1 load life , then must point pitch on file, as picture,

point start work.


Rocoo,

You might also like