Chemistry Project Work ON: Determination of Contents of Tooth Powder

CHEMISTRY PROJECT
WORK
ON
DETERMINATION OF
CONTENTS OF
TOOTH POWDER
Project Prepared By:

Mayank Kashyap
XII-A1
Roll No:
S.K.D. Academy
INDEX
1 Certificate of Authenticity
2 Acknowledgement
3 Introduction
4 Theory
5Experiment
 Aim
 Experiments’ Table
 Result
6Conclusion
7Bibliography
INTRODUCTION
Toothpowder is a powder used with hands or

with a toothbrush to clean and maintain the
aesthetics and health of teeth. Toothpowder is
used to promote oral hygiene: it can aid in the
removal of dental plaque and food from the
teeth, aid in the elimination and/or masking of
halitosis and deliver active ingredients such as
fluoride or xylitol to prevent tooth and gum
disease (gingivitis).
THEORY
While the exact formula of each brand of
toothpaste is proprietary, most toothpowders
contain the same basic ingredients. These
include:
Fluoride: Perhaps the most important
toothpowders ingredient is fluoride. Fluoride
incorporates itself into tooth enamel making
your teeth more resistant to acids produced by
plaque bacteria, as well as acids found in fruit
juices, soda (both regular and diet) and certain
foods.
In toothpowders, fluoride is found in the form
of sodium monofluorophosphate, stannous
fluoride, or sodium fluoride.
Abrasives: Abrasives give toothpowders its
cleaning power. They remove stains and
plaque, as well as polish teeth. Common
abrasives include calcium phosphates,
alumina, calcium carbonate, and silica.
Toothpowders should be abrasive enough to
remove plaque and stains, but not abrasive
enough to damage tooth enamel.
Damaged tooth enamel also causes yellowing
as the thinned enamel reveals the yellowish
dentin layer below. Over the years,
manufacturers have been quietly reducing the
abrasiveness of their toothpowders.
Preservatives: Preservatives prevent the
growth of microorganisms in toothpowders and
eliminate the need to refrigerate
toothpowders. Common preservatives include
sodium benzoate, methyl paraben, and ethyl
paraben.
Flavoring Agents: These are added to

improve the taste of toothpowders. You may
have noticed that toothpowders have very
strong flavoring.This is necessary to cover up
the horrid taste of most detergents, especially
SLS.
Sweeteners: Sweeteners also improve the
taste of toothpowders. Most toothpowder
sweeteners are artificial and contribute very
little to cavity formation. Saccharin is a
common toothpowder sweetener.
EXPERIMENT
AIM: To test the acid and basic radicals in the
toothpowder
TEST FOR ACID RADICAL I
Experiment Observations Inference
[A] Dilute H2SO4

Test:
Experiment Observation Inference
Treat the given salt s
with dilute H2SO4. No gas
[A] Dilute H2SO4 Test: evolved.
Colorless, May be
[B]Concentrated odorless gas CO3-2
H2SO4the
Treat Test:
given evolved with
sample of brisk
Heat the given
toothpowder with
sample with conc. Noeffervescenc
gas
dilute H2SO4 . evolved.
e which
H2SO4.
turns lime
water milky.
[B] Confirmatory Test
for CO3-2 :
[C] Test for PO43-
(i) MgSO4 Test:
To the aq. Solution Deep yellow POCO 3- -2
4 3
add
To a aq.solution
the few drops ofaddppt. formed confirmed.
confirme
ammonium
MgSO 4 solution.
White ppt.
or coloration d.
molybedate. formed.
is obtained.
(ii) Dilute HCl Test:
To the aq.solution add CO3-2
dilute HCl. Colorless, confirme
odorless gas d.
evolved.
TEST FOR ACID RADICAL II
TEST FOR BASIC RADICAL

Experiment Observatio Inference
ns
[A] Test for zero
group:
No Zero
To the given sample ammonical group
add NaOH. smell. absent.
[B] Test for I group:
To the aq. Solution No ppt. I group
of sample, add formed. absent.
dilute HCl.
[C] Test for II group:
To the above No ppt. II group
solution, pass H2S formed. absent.
gas.
[D] Test for III group:
To the aq. Solution No ppt. III group
of toothpowder add formed. absent.
NH4Cl followed by
NH4OH.
[E] Test for IV group:
To the above formed No ppt. IV group
solution pass H2S formed. absent.
gas.
[F] Test for V group:
White ppt. V group
To the aq. Solution formed. present.
of toothpowder add
solid NH4Cl, NH4OH
and (NH4)2CO3 .
Result: The given toothpowder contains
anions namely CO32- and PO43- and cations
namely Ca2+.
CONCLUSION
Several of the ingredients in toothpastes are
found by some environmentally damaging or
hazardous to the personal health. These
ingredients include:
 Artificial flavoring
 Artificial colors
 Triclosan
 Sodium bicarbonate (baking soda)
 Detergents
 Fluoride
 Preservatives such as Methylparaben and
Ethylparaben-parabens
 Pyrophosphate
Homemade tooth powders are made by
mixing 3 parts baking soda (cleanser)
thoroughly with 1 part salt (the abrasive).
As a direct result of these concerns, some
people have started making their own tooth
paste instead, which -while still not completely
ecologic due to the use of baking soda- still
eliminates much environmentally or health
damaging ingredients. Also, commercial
toothpowders are made which are less or even
non-environmentally damaging. Such
preparations are made from herbal resins,
propolis and myrrh.
BIBLIOGRAPHY
 Wikipedia – the free encyclopedia
 Comprehensive Practical Chemistry – XII
 www.icbse.com

Chemistry Project Work ON: Determination of Contents of Tooth Powder

Uploaded by

Copyright:

Available Formats

Chemistry Project Work ON: Determination of Contents of Tooth Powder

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Chemistry Project Work ON: Determination of Contents of Tooth Powder

Uploaded by

Copyright:

Available Formats

CHEMISTRY PROJECT

Project Prepared By:

Toothpowder is a powder used with hands or

Flavoring Agents: These are added to

Experiment Observations Inference

[A] Dilute H2SO4

TEST FOR BASIC RADICAL

You might also like