Scribd
Upload
1K views71 pages

Sony Tc-V7 Service Manual

Deck Sony TC-V7

Uploaded by

tonyroguez50
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
1K views71 pages

Sony Tc-V7 Service Manual

Deck Sony TC-V7

Uploaded by

tonyroguez50
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 71
i SPECIFICATIONS Recording system track 2channel stereo Fastlorward and rewind time ‘Approx, 100 see. (with C60 cassette) Blas frequency 105kHz Signal-tonoise ratlo (NAB, at peak level) Cassette —DOIBY NA switch [OFF | BTYPEON | GTYPE ON) TYPE IV (Sony METALLIC) wae | ee | ne [TYPE i (Sony Feci) seas | cos | 7200 TYPE NW (Sony UO wae | was | 7008 freer (Sonyeny «| sea | side | ore Tot Trarmonie distortion 4.0% (with Sony METALLIC and Fer cassettes) Frequency response DOLBY NR OFF + With TYPE IV cassette (Sony METALLIC) 20- 17,000 Hz 30 = 15,000 He (23.48) 30 13,000 He (23 d8, OVU recording) 530 15,000 Hz (DIN) += With TYPE Ill cassette (Sony FeCo) 20 16,000 Hz 30 15,000 Hz (2348) ‘30 15,000 Hz (OIN) + With TYPE Il cassette Sony UCX) 20- 16,000 Hz 30 16,000 Hz (29 68) 30 15,000 He (DIN) “= With TYPE | cassette (Sony BHF) 20 15,000 Hz 30 14,00 Hz (O1N) |wicroris 0a8=0776V Tape Transport] TeM.130RHt Mechanism Type = Continued on Page 2 — SERVICE MANUAL Wow and flutter 0.085% WAMS (NAB) 20.2% (IN) Inputs {ine inputs (phono jacks) Sensitivity 77:5 mV (-2068) Input impedance 50k ohms Line outputs (phono jacks) Gutput level 0.435 V (-5 dB) at load impedance 50k ohms Load impedance over 10k ohms Outputs SAFETY CHECK-OUT (US Model) ‘After correcting the original service problem, perform the following safety check before releasing the set to the customer: Check the antenna terminals, metal trim, “metallized” knobs, serews, and all other exposed metal parts for ‘AC leakage. Check leakage as described below. LEAKAGE TEST ‘The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must ot exceed 0.5mA (500 microampers). Leakage current can be measured by any one of three methods. 1. A commercial leakage tester, such as the Simpson 229 or RCA WT-S40A. Follow the manufacturers’ instructions to use these instru- ments. 'A battery-operated AC milliammeter. The Data Precision 245 digital multimeter is suitable for this job, 3, Measuring the voltage drop across 2 resistor by means of 2 VOM or battery-operated AC volt- meter, The “limit” indication is 0.75V, so ‘analog meters must have an accurate low: voltage scale. The Simpson 250 and Sanwa SH-63T td are examples of a passive VOM that is suitable. Nearly all battery operated digital multimeters that have 2 2V AC range are suitable, (See Fig. A) AC outlet Dimensions Weight General Power requirements AEP model: 220 V ac, 50/60 He [240 ac agjustable by authorizes Sony personne!) UK model: 240°V ae, 50/60 Hz {220V ac agjustable by authorized Sony personne!) US.Canadian model: 120V 2c, 60 Hz E model: 110, 120, 220 or 240 V ac ‘adjustable, 80/60 He US, Canadian AEP model: 1 unswitened, "00 watts max. UK model: 1 switehed, 100 watts max. Power consumption AEP, UK model: 22 watts US, Canadian model: 20 watts E model: 21 watts "ADpIOX. 388 x 80 « 280 mm (whic) iia a4, «11% incnes) Including projecting parts and controls Approx. 5ka (1110s 102) eee | Partson Fier | | suae Edsel Zsa | aru) \Fig. A. Using an AG voltmeter to check AC leakage. fs NOTES ON REPAIR When the mechanism section is operated with the set in an upside-down position, misoperation may result, For repair while operating the mechanism section, perform with the set in its normal position or standing on its side. i X Ww bi 4c He SS ° Ta i good wrong eel MODEL IDENTIFICATION “Specification label on jack plate— SONY? __ so _no.TC-V7 TAPECORDER G AEP Only US, Canadian : AC: 120V 60Hz 20W ‘AEP, G AEP : AC: 220V ~ 50/60Hz 22W UK : AC: 240V ~ 60/60H2 220 E : AC: 110, 120, 220, 240V ~ 50/60Hz 21W

You might also like