Scribd
Upload
581 views3 pages

Electrical Substation Scrutinizing and Controlling Device From Remote Area

This document describes a project to remotely monitor and control an electrical substation from a distant location. The project uses a microcontroller, RF module, and sensors to measure parameters like current, voltage and frequency at the substation. It then transmits the sensor readings via RF to a receiving station where the data is monitored on a microcontroller and LCD display. The receiving station can also send commands back through the wireless link to control devices and relays at the substation remotely.

Uploaded by

Jiiva Gopi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
581 views3 pages

Electrical Substation Scrutinizing and Controlling Device From Remote Area

This document describes a project to remotely monitor and control an electrical substation from a distant location. The project uses a microcontroller, RF module, and sensors to measure parameters like current, voltage and frequency at the substation. It then transmits the sensor readings via RF to a receiving station where the data is monitored on a microcontroller and LCD display. The receiving station can also send commands back through the wireless link to control devices and relays at the substation remotely.

Uploaded by

Jiiva Gopi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

ELECTRICAL SUBSTATION SCRUTINIZING AND CONTROLLING DEVICE

FROM REMOTE AREA


Synopsis
In interior far of places from the main transformers or electric supply stations
there is all possibilities of current fluctuations and thereby causing damages to the
materials used. Therefore there should be a security to prevent fluctuations. In remote
places it is not possible to control fluctuations at times. So it can be done by remote
control from a far off place.

Learning Objective

While doing this project, we get the opportunity to learn and understand the
following technologies,
• Microcontroller.
• RF Module.
• LCD Display

Brief Description of the Project

This project has three main functional parts:


• Microcontroller and associated circuitry.
• RF
• Sensors.
changes input measured by the sensors are fed to the microcontroller. The
controller controls the variation of current, voltage, frequency, short circuit ect. The
microcontroller also transmits the instantaneous readings of parameters to the receiver
section using the wireless transmitter module. And at the receiving station the received
information’s are monitored on the microcontroller. Electrical substation scrutinizing and
controlling device from remote area. we introducing here can capable of controlling
devices from the receiving station by sending commands through the wireless link from
our microcontroller.

Software and Hardware requirements

Development tools : Mikro C.


Components Microcontroller, RF transreceiver, Sensors
ELECTRICAL SUBSTATION SCRUTINIZING AND CONTROLLING
DEVICE FROM REMOTE AREA

LOAD
DENSOR

RELAY DRIVE

SUBSTATION
TRANSFORMER

轀˰
LINE CUT
FUSE
SENORS

RELAY

TRANSMITTER
POWER SUPPLY
LOAD
ELECTRICAL SUBSTATION SCRUTINIZING AND CONTROLLING
DEVICE FROM REMOTE AREA RECEIVER

LCD

MICROCONTROLLER
BUZZER

RECEIVER

POWER SUPPLY

You might also like