0% found this document useful (0 votes)
51 views2 pages

Image Compression

This document provides specifications for an ARM microcontroller including its architecture, processor, memory, GPIO pins, timers, ADC, DAC, communication interfaces, and packaging. It has an ARM7 processor with 32KB RAM, 512KB flash, GPIO pins, timers, RTC, 10-bit ADC and DAC, UART, SPI, I2C, and USB interfaces. The microcontroller is housed in an LQFP64 package and supports speeds up to 60MHz.

Uploaded by

Sanket Patil
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
51 views2 pages

Image Compression

This document provides specifications for an ARM microcontroller including its architecture, processor, memory, GPIO pins, timers, ADC, DAC, communication interfaces, and packaging. It has an ARM7 processor with 32KB RAM, 512KB flash, GPIO pins, timers, RTC, 10-bit ADC and DAC, UART, SPI, I2C, and USB interfaces. The microcontroller is housed in an LQFP64 package and supports speeds up to 60MHz.

Uploaded by

Sanket Patil
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

IMAGE COMPRESSION

Architecture: ARM v4T

Processor: ARM7-TDMI-S

Instructions: 32-bit ARM and 16-bit Thumb

Debug support: RT EmbeddedICE, Embedded Trace interface

Static RAM: 32 KB

(On-chip)Additional: 8 KB for USB DMA

Flash Program: 512 KB

Mem.(On-chip)Programming: ISP/IAP via on-chip boot-loader program

GPIO No. of pins: up to 45 (fast GPIO lines, 5V tolerant), Configurable to fast GPIO

External Interrupts: Four; No. of pins: Nine

Interrupts Sensitivity: Rising/falling edge or low/high level sensitive

No. of Timers: Two, 32-bit

Timer/Counter Operation: Counter or timer operation

Compare & Capture: Four channels for each timer

PWM No. of outputs: 6 single edge / 3 double edge controlled or mix; If not enabled: Used as a
standard 32-bit timer/counter

Watchdog Timer: 32-bit counter, divide by 4 fixed pre-scaler

Timer: Internally resets the chip

RTC Features: Maintains calendar, clock

Provides Seconds, Minutes, Hours, day of week, day of Month, Month, day of Year, Year.

Consumes very low power

Dedicated power pin, can use battery

Uses dedicated 32 kHz clock

No. of ADC: Two, Successive approximation type

No. of channel: 14 (ADC0 – 6 channels, ADC1 – 8 channels)

ADC Resolution: 10-bit

Conversion time: 2.44 s per channel

VREF: >2.5V, <3.3 V


IMAGE COMPRESSION

No. of DAC: One

DAC Resolution: 10-bit

VREF : 3.3 V

UART

No. of channels: Two (16C550 compliant), UART0 and UART1

Modem Interface: UART1 with full modem interface

SPI

No. of channels: One Full Duplex, Multiple master and slaves support

SSP Compatibility: Motorola SPI, 4-wire TI SSI

I2C No. of buses: Two

USB USB ports: One

Compliant: USB 2.0

Data transfer rate: Full-speed (12 Mbps)

Controller: USB Device

Special feature: 2 KB endpoint RAM

Package LQFP64 (Low profile Quad Flat Package)

128-bit memory interface

60 MHz operation

PLL, VIC, Power Control

You might also like