Scribd
Upload
81 views1 page

Fig 4.1 Flow Chart Showing Heat Treatment and Deep Cryogenic Treatment Plan

The document describes a process for heat treating and cryogenically treating an aluminum alloy. It involves selecting an aluminum alloy, performing chemical analysis, solution heat treating at 525°C for 8 hours and quenching in water, aging at 165°C for various time periods, deep cryogenic treatment at -196°C for 36 hours, conducting metallographic and mechanical testing, characterizing fractured surfaces, and analyzing and comparing results to draw conclusions.

Uploaded by

Shanmuka Sreenivas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
81 views1 page

Fig 4.1 Flow Chart Showing Heat Treatment and Deep Cryogenic Treatment Plan

The document describes a process for heat treating and cryogenically treating an aluminum alloy. It involves selecting an aluminum alloy, performing chemical analysis, solution heat treating at 525°C for 8 hours and quenching in water, aging at 165°C for various time periods, deep cryogenic treatment at -196°C for 36 hours, conducting metallographic and mechanical testing, characterizing fractured surfaces, and analyzing and comparing results to draw conclusions.

Uploaded by

Shanmuka Sreenivas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SELECTION OF MATERIAL i.

e AL 6061t6 (OR) AIMg1SiCu Alloy

Chemical analysis to check comostion

Solution heat treatment for about 08 hours at a temp of 525 C

Quenching in water at room temp

Aging for about 3,5,7 hrs at a temp of 165 C

Deep Cryogenic treatment about


36hrs at 196 C(Cooling at 196 C
3hr,Soaking-24hr, Warm up 9 Hr)

Metallographic Studies -
Micro structures at different Metallographic studies-Micro
magnifictions structures at different
magnifications

Mechanical Test Evaluation-


Tensile,Wear,Fatigue,Impact, Mechanical Test Evaluation- Tensile,
Bending,Hardness wear,Fatigue,Impact,Bending,Hardn
ess

Characterization of Fractured
surfaces SEM,SEM-EDAX & Charcterization of Fractured
XRD surfaces SEM,SEM-EDAX and
XRD

Analyzing of Results, Comparison & Evolving Conclusion

Fig 4.1 Flow Chart Showing heat treatment and deep cryogenic treatment plan

You might also like