Scribd
Upload
35 views3 pages

The Cylinder Vessel of Inner Diameter 8 Inch With Hemispherical End Caps. The Vessel Has A Wall Thickness of 0.5 Inch Where The Centers of Hemisphere Are 15 Inch Apart

The document outlines the aims of 12 SolidWorks modeling, simulation, and machining projects. These include drawing 2D sketches, modeling 3D parts with dimensions, assembling parts, performing stress analysis with applied pressure, steady state heat transfer analysis, natural frequency analysis of a beam, profile milling, step turning, and step turning with threading to generate various components. One project involves modeling a cylindrical vessel with hemispherical end caps of specified dimensions.

Uploaded by

mdahasan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
35 views3 pages

The Cylinder Vessel of Inner Diameter 8 Inch With Hemispherical End Caps. The Vessel Has A Wall Thickness of 0.5 Inch Where The Centers of Hemisphere Are 15 Inch Apart

The document outlines the aims of 12 SolidWorks modeling, simulation, and machining projects. These include drawing 2D sketches, modeling 3D parts with dimensions, assembling parts, performing stress analysis with applied pressure, steady state heat transfer analysis, natural frequency analysis of a beam, profile milling, step turning, and step turning with threading to generate various components. One project involves modeling a cylindrical vessel with hemispherical end caps of specified dimensions.

Uploaded by

mdahasan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

1. Aim: To draw the given 2D-Sketch by using solid works.

2. Aim: To draw the given 2D-Sketch by using solid works.

3. Aim: To Model the given 3D-Part with Dimensions by using solid work.

4. Aim: To Model the given 3D-Part with Dimensions by using solid work.

The cylinder vessel of inner diameter 8 inch with hemispherical end caps. The vessel has a wall
thickness of 0.5 inch where the centers of hemisphere are 15 inch apart.
5. Aim: To assemble the given 3D parts by using solid works.

6. Aim: To determine the deflections, vonmisses stresses of given axi-symmentric component


with pressure 3N/mm² for "cast carbon steel" material.

The cylinder vessel of inner diameter 8 inch with hemispherical end caps. The vessel
has a wall thickness of 0.5 inch where the centers of hemisphere are 15 inch apart.

7. Aim: To Analyze steady state heat transfer analysis of the given plate component of
temperature 700°c one side and 400°c of another side for "chromium copper" material.

Height= 50mm; Length= 100mm; Hole: 30mm; Thickness:4mm

8. Aim: To Estimate the Natural frequencies and mode shapes of 2DBeam fixed at both ends.

Length =100mm, width =80mm, Extrude length =5000mm.


9. Aim: To perform rectangular profile milling to generate the component as shown in figure

10. Aim: To perform profile milling to generate the component as shown in figure

11. Aim: To perform step turning operation to generate the component as shown in figure

12. Aim: To perform step turning and threading operation to generate the component as shown
in figure

You might also like