0% found this document useful (0 votes)
16 views1 page

Compulsary Questions: Angular Unconfirmity

This document contains 5 compulsory questions about oil and gas geology terms. The questions ask about the name of an unconformity based on a picture, the type of drilling used when mud pressure is lower than formation pressure, the final stage of preparing a well for production, the type of log used to determine resistivity in flushed zones while minimizing mudcake and borehole effects, and the definition of cement strength in holding horizontal and formation pressures. The document provides short answers to identify each oil and gas term.

Uploaded by

FiktoriusKevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
16 views1 page

Compulsary Questions: Angular Unconfirmity

This document contains 5 compulsory questions about oil and gas geology terms. The questions ask about the name of an unconformity based on a picture, the type of drilling used when mud pressure is lower than formation pressure, the final stage of preparing a well for production, the type of log used to determine resistivity in flushed zones while minimizing mudcake and borehole effects, and the definition of cement strength in holding horizontal and formation pressures. The document provides short answers to identify each oil and gas term.

Uploaded by

FiktoriusKevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Compulsary Questions 8

1. What is the name of this unconformity based on the picture?

Answer : Angular Unconfirmity

2. Drilling was carried out where the mud hydrostatic pressure is smaller than
the formation pressure. This method is suitable for the sensitive / reactive
formation. What is the type of the drilling?
Answer : Underbalance Drilling

3. The final stage of the work or improvement work to prepare a drilling wells
to be the production wells is definition of..
Answer : Well Completion

4. This type of log is used to determine resistivity formation in the flushed zone.
The other measurements are focused to minimize the effect of mudcake and
rogues hole. This log is usually combined with a laterolog or induction log to
correct the latter for the effects of invasion and for saturation determination in
quick-look ratio methods. What is the name of this log?
Answer : Microresistivity Log

5. The strength of cement in holding the pressures that come from the formation
as well as from the casing or holding the pressure in the horizontal direction,
is the definition of...
Answer : Compresive Strength

Preliminary Round Student Competition OGIP 2011

You might also like