Scribd
Upload
51 views4 pages

LF-Example B1 - Exercise

This document describes a load flow example with a system containing various elements like MOV switches, lump loads, static loads, capacitors, and synchronous motors. It provides the element parameters and load flow results for the example system.

Uploaded by

Bambang Arie S
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views4 pages

LF-Example B1 - Exercise

This document describes a load flow example with a system containing various elements like MOV switches, lump loads, static loads, capacitors, and synchronous motors. It provides the element parameters and load flow results for the example system.

Uploaded by

Bambang Arie S
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Load Flow Example B1

1. Build the following system

Element Parameters
Type Element Parameters
MOV MOV3, MOV5 Initial Status = Throttle
Lump Load Lump2 PF=85%, Constant kVA Load = 50%, Rated kV = 13.8
Lump4 & Lump 6 PF=85%, Constant kVA Load = 80%, Rated kV = 0.46
Static Load Load1, Load6, Load8 kV = Bus Nominal kV, PF=80%
Load3, Load5 kV = Bus Nominal kV, PF=100%
Capacitor CAP1 kV=4.16, kvar/Bank = 150 kvar, # of Banks = 2
Syn Motor Syn1 PF @ 100% Load = 80%, FLA = 403.5
Syn2, Syn4 PF@100% Load =91.71%, FLA = 220.1

ETAP Workshop Notes ©1996-2010 Operation Technology, Inc. Page 1 of 4


Load Flow Example B1

ETAP Workshop Notes ©1996-2010 Operation Technology, Inc. Page 2 of 4


Load Flow Example B1

2. Run Load Flow. Results are displayed below.

ETAP Workshop Notes ©1996-2010 Operation Technology, Inc. Page 3 of 4


Load Flow Example B1

ETAP Workshop Notes ©1996-2010 Operation Technology, Inc. Page 4 of 4

You might also like