Scribd
Upload
19 views1 page

Pulsary Question (SF)

The document contains 5 multiple choice questions about oil and gas engineering concepts. Question 1 asks about isoporosity maps, question 2 asks about the name of wellhead equipment, question 3 provides a calculation to determine a J-function value given reservoir parameters, question 4 asks about wettability classification given a contact angle, and question 5 asks about two types of thermal displacement methods used in the oil industry.

Uploaded by

FiktoriusKevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
19 views1 page

Pulsary Question (SF)

The document contains 5 multiple choice questions about oil and gas engineering concepts. Question 1 asks about isoporosity maps, question 2 asks about the name of wellhead equipment, question 3 provides a calculation to determine a J-function value given reservoir parameters, question 4 asks about wettability classification given a contact angle, and question 5 asks about two types of thermal displacement methods used in the oil industry.

Uploaded by

FiktoriusKevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Compulsary Question 3

1. What types of maps that illustrating the contour lines show the places with
the same porosity?
Answer : Isoporosity Map

2. Well control equipment on the surface made of steel to form an insulation


system to withstand a blast or leakage of well fluids to the surface composed
of the head casing (casing hanger) and tubing head (tubing hanger). What is
the name of the equipment?
Answer : Well Head

3. Calculate the J-function


The interfacial tension is measured at 50 dynes/cm. Further reservoir
engineering analysis indicated that the reservoir is better described at a
porosity value of 16% and an absolute permeability of 120 md. Water
saturation 0.6. Capillary Pressure 0.75 psi
Answer : 0.052
Pc k
J ( S w )  0.1264
 cos( ) 

0,75 120
J (S w )  0.1264  0.052
50 0.19

4. What is Type of this wettability if the rock has a contact angle of fluid ( oil
and water) about the rock itself which bigger than 900 (θ > 900) ?
Answer : Oil wet

5. Mention two types of thermal displacement which often used in the oil
industry to improve oil recovery factor
Answer : Steam injection, In-situ combustion

Semi-Final

You might also like