0% found this document useful (0 votes)
112 views3 pages

Op-Tech Usage Notes: Given in The Slip

This document provides usage notes for an ultrasonic testing software program contained on a CD. It notes that the software runs on Windows 98, 2000, or XP systems with at least 128MB of RAM and a screen resolution of 800x600 pixels or higher. No installation is required as the software runs directly from the CD. The CD also contains a Flash player installer if needed. The software runs for around 60 minutes and includes navigation buttons to move between scenes. Contact information is provided for technical support.

Uploaded by

Asish desai
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
112 views3 pages

Op-Tech Usage Notes: Given in The Slip

This document provides usage notes for an ultrasonic testing software program contained on a CD. It notes that the software runs on Windows 98, 2000, or XP systems with at least 128MB of RAM and a screen resolution of 800x600 pixels or higher. No installation is required as the software runs directly from the CD. The CD also contains a Flash player installer if needed. The software runs for around 60 minutes and includes navigation buttons to move between scenes. Contact information is provided for technical support.

Uploaded by

Asish desai
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

OP-TECH

Usage Notes

This CD contains the NON DESTRUCTIVE TESTING on

ULTRASONIC TESTING
System requirements:

This software runs on any IBM compatible Pentium PC having WINDOWS98,


WINDOWS2000 or WINDOWS XP operating system. It may run on other windows
platforms though we have not tested this CD on them.

For good response minimum RAM size of 128 mb is required.

Please set the video to 800 x 600 with 16 or 32 bit color.

Installation:

No specific installation is required for running the CD. The Software can be run directly
from the CD itself.

The autorun feature is enabled so the software runs just by inserting the CD in the
CD-ROM drive. In case the autorun feature is disabled you may manually start the

software by double clicking on the icon.

When asked please key in the CD KEY as given in the slip and press “GO” to
complete the installation process.

The software requires Flash Player. In case your system does not have flash player
installed, you may install it from the CD. The Flash player setup program is available in the
Flash Player folder in the CD. Alternatively you may also download the latest flash player
from the site www: macromedia.com for free.

Usage:

The software runs for about 60 minutes. This time may vary depending on the time the
student spends on each scene. Between scenes you are requested to press the next
button to move to the next scene.

If you notice clipping at the borders, please adjust the video resolution to 800 x 600. This
can be done by right clicking on any vacant area (non icon area) of the desktop and
access properties  setting  screen resolution. Move the slider bar as required.

The print out has been adjusted for an inkjet printer. So the printed output may vary a little
if a different printer is used. You may adjust the default setting of the printer before starting
the application to correct any variations.
The following diagram describes the different buttons and their functionality:
Navigation Buttons:

Close
Button

Chapter Mute Next Previous


Button Button Button Button

Please note that few of the buttons are active only when voice over is available.

EXIT

Exits the application.

PREVIOUS
Takes you to the previous scene.

NEXT

Takes you to the next scene. By pressing the PREVIOUS and NEXT buttons in a
sequence the user may replay the same scene.

You may contact us at the following address

OP-TECH
No 6/9, VII Cross street,
Karpagam Gardens,
Adyar,
Chennai – 600 020.

Phones: (9144) 24461159 (91) 98406 24625

E Mail: [email protected]

shsihtas

You might also like