Scribd
Upload
536 views2 pages

Isolation Transformer Datasheet

These single phase isolation transformers provide extremely low noise and leakage to make them suitable for isolated power systems in medical facilities. They have Class H insulation, electrostatic shielding between windings, and vibration damping to isolate the core and coils from the enclosure. The transformers meet various safety standards with leakage currents under 50 microamps and sound levels from 25-35 decibels depending on the kVA rating. They are available from 3 to 25 kVA and are UL and CSA recognized for medical use.

Uploaded by

Oliver Hermosa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
536 views2 pages

Isolation Transformer Datasheet

These single phase isolation transformers provide extremely low noise and leakage to make them suitable for isolated power systems in medical facilities. They have Class H insulation, electrostatic shielding between windings, and vibration damping to isolate the core and coils from the enclosure. The transformers meet various safety standards with leakage currents under 50 microamps and sound levels from 25-35 decibels depending on the kVA rating. They are available from 3 to 25 kVA and are UL and CSA recognized for medical use.

Uploaded by

Oliver Hermosa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Isolation Transformers

Medical Division of Bender Inc. Medical Products Group

Transformer Dimension Diagram Single Phase Low Profile


Product Description
These transformers provide extremely low
noise and low leakage. (less than 50
microamps.) This makes them particularly
suitable for use in Isolated Power Systems.
Such systems find wide usage in critical care
areas as ORs, ICUs, CCUs, etc. where an
extra layer of electrical safety is desirable.
Suggested technical specifications
• Single phase, 50 or 60 Hz, with primary and
secondary voltages as indicated on the contract
drawings.

• Class H rated insulation


Dimension Table (inches)
• Electrostatic shield between primary and
kVA A B C D E secondary windings grounded to enclosure.

3.0 14.0 13.25 12.0 3.5 2.5 • Electrostatic shield designed in a way to
5.0 14.0 15.0 12.0 4.0 2.5 prevent direct shorting of primary to secondary
7.5 16.0 15.0 15.25 4.5 2.125 windings, and reduce the coupling of harmonic
10.0 14.0 14.0 12.0 6.0 4.5 distortions between primary and secondary
15.0 15.0 15.0 12.0 6.5 4.5 circuits.
20.0 16.0 18.75 11.0 8.0 6.0
25.0 16.0 18.75 11.0 9.0 6.75 • Core and coils isolated from enclosure by
means of suitable vibration dampening system.

Technical Data • Total leakage current to ground from


kVA Leakage current * Noise % % Wt. transformer secondary winding in compliance
with UL1047, tables 30.1 and 30.2 and CSA
120V 208~277V dB Imp. Reg. Lb. Z32.2.
sec. sec.
• Maximum sound level of transformer: 25 dB
3.0 12 18 25 3.75 3.0 65 for units 5KVA or less, 30dB for 7.5KVA, 35dB
5.0 20 30 25 3.60 2.6 85 for 10 - 15KVA units.
7.5 22.5 33.5 30 3.50 2.6 110
10 25 37 35 4.10 2.6 170 • Temperature rise limited to 115 degree C
15 30 40 35 4.10 2.6 170 above ambient under full load conditions.
20 32 44 40 4.00 3.0 260
25 34 51 40 4.00 3.0 320 • Transformer UL and CSA recognized as a
component, at the voltages, amperages and
*Maximum Leakage Current (Micro Amps) KVA ratings required.

ISOTROL SYSTEMS / BENDER MEDICAL PRODUCTS Contact factory for information on three
700 Fox Chase phase transformers
Coatesville, PA 19320
Phone: 800-833-6834 800-356-4266
610-383-9655 610-383-9200 Recognized
Fax: 610-383-7100
E-mail: [email protected] [email protected] Specifications and other data subject to change without notice. Rev 2 - 2004 LST
Medical Division of Bender Inc. Medical Products Group

You might also like