Scribd
Upload
373 views1 page

Sheet 1

This document contains problems related to determining shear and moment diagrams for mechanical engineering structures. Problem 1 asks to determine tensions in a chain and draw shear and moment diagrams for an arm supporting a load. Problem 2 asks to draw shear and moment diagrams for a crane boom supporting an engine. Problem 3 asks to draw shear and moment diagrams for a shaft supported by bearings and loaded by pulleys.

Uploaded by

AmrAli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
373 views1 page

Sheet 1

This document contains problems related to determining shear and moment diagrams for mechanical engineering structures. Problem 1 asks to determine tensions in a chain and draw shear and moment diagrams for an arm supporting a load. Problem 2 asks to draw shear and moment diagrams for a crane boom supporting an engine. Problem 3 asks to draw shear and moment diagrams for a shaft supported by bearings and loaded by pulleys.

Uploaded by

AmrAli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Benha University M1261

Benha Faculty of Engineering Strength & Testing of Materials


Mechanical Engineering Department 2nd Year Mechanical Engineering
Dr. Abdalla M. Abdalla Sheet # 1

1) The load binder is used to support a load. If the


force applied to the handle is 50 lb, determine
the tensions T1 and T2 in each end of the chain
and then draw the shear and moment diagrams
for the arm ABC.

5) The industrial robot is held in the stationary


position shown. Draw the shear and moment
diagrams of the arm ABC if it is pin connected
at A and connected to a hydraulic cylinder (two-
2) The engine crane is used to support the engine, force member) BD. Assume the arm and grip
which has a weight of 1200 lb. Draw the shear have a uniform weight of 1.5 lb/in. and support
and moment diagrams of the boom ABC when it the load of 40 lb at C.
is in the horizontal position shown.

3) Draw the shear and moment diagrams for the


shaft. The bearings at A and D exert only
vertical reaction on the shaft. The loading is 6) For the cantilever beam and loading shown,
applied to the pulleys at B and C and E. derive equations for the shear force and the
bending moment for any location in the beam
(place the origin at point A).

4) Members ABC and BD of the counter chair are


rigidly connected at B and the smooth collar at 7) For the simply supported beam subjected to the
D is allowed to move freely along the vertical loading, derive equations for the shear force and
slot. Draw the shear and moment diagrams for the bending moment for any location in the
member ABC. beam (place the origin at point A).

Page 1 of 1

You might also like