Scribd
Upload
248 views1 page

Assignment of Control Engineering

This document contains an assignment for a Control Engineering course. It provides 7 questions asking students to draw block diagrams for various feedback control systems, including a rolling machine, radar antenna position control, humidity control for an air conditioner, temperature control for a boiler, sun tracking for solar power, and air filling for car tires. Students are instructed to label components clearly and provide a brief description of how each system works. Late assignments will not be accepted.

Uploaded by

ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
248 views1 page

Assignment of Control Engineering

This document contains an assignment for a Control Engineering course. It provides 7 questions asking students to draw block diagrams for various feedback control systems, including a rolling machine, radar antenna position control, humidity control for an air conditioner, temperature control for a boiler, sun tracking for solar power, and air filling for car tires. Students are instructed to label components clearly and provide a brief description of how each system works. Late assignments will not be accepted.

Uploaded by

ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Capital University of Science and Technology Islamabad

Department of Mechanical Engineering


Control Engineering (Fall-2018)
Assignment # 1
Due Date: 02-10-18

Note:
1- Block diagrams should be handmade and a give a small description of its working.
2- Assignment should be neat and clean.
3- Late assignments will not be accepted.

Q-1 In a rolling machine, the required metal thickness is achieved by using a feedback control system
as shown below. Draw the block diagram of the system.

Q-2 Consider the following closed loop block diagram. What are the signals Y and Z.? What is a
sensor. If the driver is replaced by an electronic device: what do, we call this device and what do
we call the closed loop system.

Q-3 Draw a block diagram to control the radar antenna position. Mention the controller and the
feedback sensor.

Q-4 Draw block diagram for a humidity control system for an Air-conditioner. Mention the control
component and the sensor used explicitly.

Q-5 Draw block diagram of temperature control system of a boiler. Also mention the component
clearly.

Q-6 Draw block diagram of a sun tracking system for a solar power system. Also mention the
component clearly.

Q-7 Draw block diagram for air filling system in car tires with feedback control system such that it
stops when the desired pressure is achieved.

You might also like