Backer Rod Brochures - 2pages

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Jointflex Backer Rod

Description.
Jointflex Backer Rod’s are manufactured from closed cell polyethylene, are non-absorbing,
are U.V resistant and have excellent weather ability properties.

Product Applications.
Jointflex Backer Rod’s are used in joints in pre-cast and cast-in-situ concrete elements to give
support to the joint sealant application, aid in the correct joint sealant geometry (application
depth and shape) and prevent the joint sealant from adhering to the top of the expansion
joint filler board (3-way bonding), acting as a bond breaker.

Product Advantages.
Non-absorbent Lightweight
Excellent weather ability Resistant to ultraviolet light
No bitumen content Ability to compress and recover
Acts as a bond breaker

Available Sizes.
Jointflex Backer Rod’s are available in a number of different diameters and also available in
square section sizes to suit your requirement. Square sections are available with or without an
adhesive face (refer to table over leaf).

Installation.
Choose a diameter or square section which is approximately 20% to 25% bigger than the
actual joint size so it can be compressed to fit inside the joint leaving a tight and firm fit. Apply
the backer rod to your specified depth for the sealant application.

For square sections, which have a self-adhesive side, the surface must be clean, dry and free
from dust. The adhesive paper is removed prior to the application and the seal is placed onto
the pre-cast or first concrete element. All joins must be placed by butting firmly together.

Available sizes.
Jointflex Backer Rod’s are available in roll lengths for round shapes and available in lengths of
1 metre, 1.5 metre and 2 metre for square sections.

Standard diameter sizes are 6mm up to 80mm.

Section sizes are as follows: 10mm x 10mm, 15mm x 15mm, 20mm x 20mm and 25mm x 25mm.
Custom diameter and section sizes can be easily manufactured to suit.

Specification.
Jointflex Backer Rod’s shall be detailed and installed strictly in accordance to Corkjoint’s
recommendations and technical requirements.
Physical Applications.

Joint Sealant

Backer Rod Joint Sealant

Backer Rod

Backer Rod
Fillerboard

Joint Sealant

Expansion Joint In Slab On Ground Expansion Joint In Wall

Physical Properties. Choice of Section.

Property Result Units Width of Joint Diameter Section


Density 33 Kg/m3 10mm 13mm 13 x 13
Compression Set 15 % 15mm 20mm 20 x 20
Compression Stress 13 kPa 20mm 25mm 25 x 25
Water Absorption below 3.0 g/m2d 25mm 30mm 30 x 30
Elongation 80 %
30mm 38mm 35 x 35
Tensile strength 0.18 N/mm2
Other size diameters and sections are available
Temperature
-40 to + 95 Celsius
strength

Please enquire about our range of construction products

Malaysia : CORKJOINT (M) SDN BHD Singapore : CORKJOINT (S) PTE LTD
Phone : (603) 6250 9630 Phone : (65) 6455 9331
Fax : (603) 6250 9650 Fax : (65) 6455 8535

You might also like