Service Codes Quick Reference List

Service Codes Quick Reference List
NOTE:
If any of the following service codes should appear, see your authorized dealer.
SERVICE CODES
HFWD SYSTEM CODES F301 Transmission Solenoid 1 Low F317 Bottom Switch Open with Top
(S.N.-567461): or Zero Current Switch Closed. Not a possible
condition of operation.
F210 HFWD Pump Malfunction F302 Transmission solenoid 2 Low F318 Inching Potentiometer Out of
or Zero Current Range Low
F211 Loss of Front Wheel F303 Transmission Solenoid 3 Low F319 Inching Potentiometer Out of
Speed Sensor or Zero Current Range High
F213 No Input Power or F304 Transmission Solenoid 4 Low START-UP SYSTEM CODES
Aggressive Switch Unplugged or Zero Current (S.N. 567180-):
F214 Invalid F305 Transmission Solenoid A F320 Park/Start wire (E02) to
Low or Zero Current Transmission Controller is at GND
when Starting.
F215 Invalid F306 Transmission Solenoid B Low F321 Started with Shifter Not in
or Zero Current Park.
F216 Invalid F307 Transmission Solenoid C Low F322 Park Brake Pressure Switch
or Zero Current Open While Starting Grader.
F217 TCU Controller Not F308 Transmission Solenoid D SHIFTING (PARK or NEUTRAL
Communicating with HFWD Low or Zero Current into GEAR) SYSTEM CODES:
Controller
F218 HFWD Controller Not F309 Transmission Solenoid 1 Over F323 FWD/REV Switch (S12)
Communicating with FWD Current Indicates Transmission is in Neutral
Pump Controller and Gear at same time
F219 Invalid F310 Transmission Solenoid 2 Over F324 FWD/REV Switch Indicates
Current Shift Handle is in Neutral while Shift
Handle is in Gear.
F220 Invalid F311 Transmission Solenoid 3 Over F325 Forward and Reverse on at the
Current same time.
F221 Invalid F312 Transmission Solenoid 4 Over F326 Shifter Handle in Neutral or
Current Gear and Park Brake Stays on.
F222 Invalid F313 Transmission Solenoid A F327 Shifter Handle is in Forward or
Over Current Reverse and Park Brake comes on.
F223 Invalid F314 Transmission Solenoid B F328 Park Brake On with Shifter in
Over Current Park Position, with at least one Gear
Position Switch on.
HFWD SYSTEM CODES F315 Transmission Solenoid C F329 Park Brake or Park Brake
(S.N. 567462-): Over Current Pressure Switch Problem.
F210 FWD Pump Electrical F316 Transmission Solenoid D (S.N. -567461):
Malfunction Over Current
F211 Loss of Front Wheel INCHING PEDAL SYSTEM F330 Shifter ABCDE Switch Unit
Speed Sensor CODES (S.N. -567179): Problem 1 or 5 Bit Gear Code
F213 No Input Power or F317 Bottom Switch Open with F331 Shifter ABCDE Switch Unit
Aggressive Switch Unplugged Top Switch Closed. Not a possible Problem. 2 Bit Gear Code while
SERVICE CODES
condition of operation. going from Neutral to Gear.
F217 TCU Controller Not F318 Inching Potentiometer Out of F332 Shifter ABCDE Switch Unit
Communicating with HFWD Range Low Problem. 2 Bit Gear Code while
Controller going from Neutral to Gear.
F218 HFWD Controller Not F319 Inching Potentiometer Out of F333 Shifter ABCDE Switch Unit
Communicating with FWD Range High Problem. 4 Bit Gear Code while
Pump Controller. going from Neutral to Gear.
SERVICE CODES
TRANSMISSION GEAR INCHING PEDAL F334 Shifter ABCDE Switch Unit
SOLENOID SYSTEM CODES: SYSTEM CODES (S.N. Problem. 4 Bit Gear Code while
567180-): going from Neutral to Gear.
F335 ABCDE Switch Problem. F399 TCU Software did not F453 Rack Instability
Voltage Sense Low from Gear recognize Service Code
Switch Unit.
(S.N. 567180-): ENGINE SYSTEM CODES:
F330 One Bit or Five Bit Code. F411 Throttle Position Sensor
(Voltage Too High)
F335 Low Shifter Voltage F412 Throttle Sensor (Voltage
Too Low)
F336 Started in Gear F416 Air Temperature Sensor
(Input Voltage Too High)
F337 Loss of Forward or Reverse F417 Air Temperature Sensor
Signal while in Gear. (Input Voltage Too Low)
SHIFTING (PARK or NEUTRAL F421 Throttle Sensor (Supply
into GEAR) SYSTEM CODES: Voltage Too High)
F338 Return to Park, Park Switch F422 Throttle Position Sensor
stays On. (Supply Voltage Too Low)
F339 Shifter Failure F428 Engine Controller
Failure
F340 System Configuration Error F431 Rack Actuator/Position
Sensor (Measurement Error)
F341 HFWD Controller - No F434 Rack Actuator (Position
Communication Error)
F342 Engine Controller - No F435 Rack Position Sensor
Communication (Voltage Too High)
F343 Transmission Oil Temperature F436 Rack Position Sensor
Sensor or Circuit Problem (Voltage Too Low)
F345 Undefined Gear Request F437 Fuel Temperature
Sensor
F346 Controller Error F438 Fuel Temperature
Sensor
F347 Controller Error F439 Injection Pump Speed
Sensor
F348 Transmission Output Power F441 Key Switch Signal
Low
F375 Input Shaft Speed Pickup Open F442 Engine Overspeed
SERVICE CODES
Circuit
F376 Output Shaft Speed Pickup F444 Engine Speed Sensor
Open Circuit
F377 No Output Speed Sensor F445 Engine Speed Signal
Mismatch
F391 EEprom Check Sum Error F446 Key Switch Always On
F398 Communications Locked, F448 Fuel Shutoff Circuit
Corrupted Program
CED,OUOE002,1348-19-
1999/07/20

Service Codes Quick Reference List

Uploaded by

Copyright:

Available Formats

Service Codes Quick Reference List

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Read this document in other languages

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Service Codes Quick Reference List

Uploaded by

Copyright:

Available Formats

What are some of the transmission solenoid system codes listed?

What are some of the engine system codes listed?

Service Codes Quick Reference List

You might also like