DC/DC Converters: Features
DC/DC Converters: Features
DC/DC Converters: Features
CB
Scheme
Features UL 60950-1
Models
Ordercode Input voltage range Output voltage Output current max. Efficiency typ.
TEN 3-0510 3.3 VDC 600 mA 70 %
TEN 3-0511 5 VDC 500 mA 73 %
TEN 3-0512 12 VDC 250 mA 77 %
TEN 3-0513 4.5 – 9.0 VDC 15 VDC 200 mA 77 %
TEN 3-0521 (nominal 5 VDC) ±5 VDC ±250 mA 72 %
TEN 3-0522 ±12 VDC ±125 mA 75 %
TEN 3-0523 ±15 VDC ±100 mA 75 %
TEN 3-1210 3.3 VDC 600 mA 74 %
TEN 3-1211 5 VDC 500 mA 78 %
TEN 3-1212 12 VDC 250 mA 82 %
TEN 3-1213 9 – 18 VDC 15 VDC 200 mA 82 %
TEN 3-1221 (nominal 12 VDC) ±5 VDC ±250 mA 77 %
TEN 3-1222 ±12 VDC ±125 mA 80 %
TEN 3-1223 ±15 VDC ±100 mA 80 %
TEN 3-2410 3.3 VDC 600 mA 76 %
TEN 3-2411 5 VDC 500 mA 79 %
TEN 3-2412 12 VDC 250 mA 84 %
TEN 3-2413 18 – 36 VDC 15 VDC 200 mA 84 %
TEN 3-2421 (nominal 24 VDC) ±5 VDC ±250 mA 79 %
TEN 3-2422 ±12 VDC ±125 mA 82 %
TEN 3-2423 ±15 VDC ±100 mA 82 %
TEN 3-4810 3.3 VDC 600 mA 76 %
TEN 3-4811 5 VDC 500 mA 79 %
TEN 3-4812 12 VDC 250 mA 84 %
TEN 3-4813 36 – 72 VDC 15 VDC 200 mA 84 %
TEN 3-4821 (nominal 48 VDC) ±5 VDC ±250 mA 80 %
TEN 3-4822 ±12 VDC ±125 mA 84 %
TEN 3-4823 ±15 VDC ±100 mA 84 %
http://www.tracopower.com Page 1 of 3
DC/DC Converters
TEN 3 Series 3 Watt
Input Specifications
Input current no load / full load 5 Vin models 40 mA / 800 mA typ.
12 Vin models 20 mA / 300 mA typ.
24 Vin models 5 mA / 150 mA typ.
48 Vin models 3 mA / 75 mA typ.
Start-up voltage / 5 Vin models 4 VDC / 3.5 VDC typ.
under voltage shut down 12 Vin models 7 VDC / 6.5 VDC typ.
24 Vin models 12 VDC / 11 VDC typ.
48 Vin models 24 VDC / 22 VDC typ
Surge voltage (1 sec. max.) 5 Vin models 11 V max.
12 Vin models 25 V max.
24 Vin models 50 V max.
48 Vin models 100 V max.
Reverse voltage protection 1.0 A max.
Conducted noise (input) (5 V input models excluded) EN 55022 level A, FCC part 15, level A
Output Specifications
Voltage set accuracy ±1 %
Regulation – Input variation Vin min. to Vin max. 0.5 % max.
– Load variation 10 – 100 %
single output models 0.5 % max.
dual output models balanced load 1.0 % max.
dual output models unbalanced load 2.0 % max.
Ripple and noise (20 MHz Bandwidth) 60 mVpk-pk max
Transiente response – Recovery time 500 μs max.
(25% load step change) – Deviation 5 % max.
Temperature coefficient ±0.02 %/K
Current limitation >110 % of Iout max., constant current
Short circuit protection indefinite, automatic recovery
Capacitive load single output models 4000 µF max.
dual output models 1000 µF max. (each output)
General Specifications
Temperature ranges – Operating –40°C to +85°C
– Case temperature +100°C max.
– Storage –55°C to +125°C
Derating 3 %/K above 70°C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217 F, at +25°C, ground benign) >1.1 Mio. h
Isolation voltage (60 sec.) – Input/Output 1’500 VDC
Isolation capacitance – Input/Output 65 pF typ
Isolation resistance – Input/Output (500 VDC) >1‘000 M Ohm
Switching frequency 300 kHz typ. (Pulse frequency modulation PFM)
Safety standards cUL/UL 60950-1, IEC/EN 60950-1
Environmental compliance – Reach www.tracopower.com/info/reach-declaration.pdf
– RoHS directive 2011/65/EU
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com Page 2 of 3
DC/DC Converters
TEN 3 Series 3 Watt
Physical Specifications
Casing material non conductive FR4
Potting material epoxy (UL 94V-0 rated)
Weight 12.4 g (0.44 oz)
Soldering temperature max. 265°C / 10 sec.
Outline Dimensions
Pin-Out
2 3 9 11
Pin Single Dual
(0.6)
20.3
(0.8)
16 –Vout Common
22 +Vin (Vcc) +Vin (Vcc)
23 +Vin (Vcc) +Vin (Vcc)
(0.4)
10.2
(0.18)
4.5
31.8 (1.25)
Specifications can be changed without notice! Make sure you are using the latest documentation, downloadable at www.tracopower.com
Rev. July 24, 2018
www.tracopower.com Page 3 of 3