Scribd
Upload
371 views1 page

Wiring Additional Temperature Sensors To Alternate Av Inputs

This document provides instructions for wiring additional temperature sensors to alternate analog voltage inputs (AVIs) on a Haltech ECU connector. To connect a temperature sensor to a spare AVI, a 1k ohm pull-up resistor must be connected between the AVI and +5V DC supply. The diagram shows how to connect a temperature sensor to AVI1 specifically.

Uploaded by

jameel babooram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
371 views1 page

Wiring Additional Temperature Sensors To Alternate Av Inputs

This document provides instructions for wiring additional temperature sensors to alternate analog voltage inputs (AVIs) on a Haltech ECU connector. To connect a temperature sensor to a spare AVI, a 1k ohm pull-up resistor must be connected between the AVI and +5V DC supply. The diagram shows how to connect a temperature sensor to AVI1 specifically.

Uploaded by

jameel babooram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

WIRING ADDITIONAL TEMPERATURE

SENSORS TO ALTERNATE AV INPUTS

TEMPERATURE SENSOR
HALTECH ECU CONNECTOR

1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7

10 11 12 13 14 15 16 17 8 9 10 11 12 13

18 19 20 21 22 23 24 25 14 15 16 17 18 19
B A
26 27 28 29 30 31 32 33 34 20 21 22 23 24 25 26

INSERT WIRE THROUGH PLUG,THEN CRIMP THE PIN ONTO THE WIRE
DRAW BACK TO LOCK
A B
LOOKING INTO CONNECTOR
B A
TO CONNECT AN OPTIONAL TEMPERATURE SENSOR
TO ANY OF THE SPARE AV INPUTS A 1K PULL UP RESISTOR
[O] +5V DC MUST BE CONNECTED AS SHOWN IN THE DIAGRAM BELOW.
A9 THE DIAGRAM REFLECTS THE CONNECTION OF THE
SENSOR TO AVI1.

1K PULL UP
HALTECH
RESISTOR
ECU
CONNECTOR SENSOR CONNECTOR

[GY/Y] AVI1
B13 B HALTECH TEMPERATURE SENSOR
B A
[B/W] SIGNAL GROUND
B14
A LOOKING INTO CONNECTOR
HALTECH TEMP SENSOR WIRING
HALTECH, SYDNEY AUSTRALIA
DATE: 18TH MAY 2009
REV A SHEET 1 OF 1

You might also like