Scribd
Upload
396 views1 page

Mirror Installation Method

Installation Procedure 1. Mirrors must be cleaned and dried after processing, especially around edges, to prevent scratching or peeling of the backpaint. Wall surfaces must also be cleaned, dry, and protected from moisture. 2. Poly plywood is commonly used as a mounting surface and must be dry, with nail heads sealed to prevent contact with the backpaint. 3. Mirrors are mounted using stainless steel screws with protective collars through pre-cleaned, dry holes to prevent contact between the mirror and hard materials. A 3-5mm gap is maintained for ventilation, especially for wet areas. Larger mirrors use top and bottom supports for safety.

Uploaded by

mudassir2640
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
396 views1 page

Mirror Installation Method

Installation Procedure 1. Mirrors must be cleaned and dried after processing, especially around edges, to prevent scratching or peeling of the backpaint. Wall surfaces must also be cleaned, dry, and protected from moisture. 2. Poly plywood is commonly used as a mounting surface and must be dry, with nail heads sealed to prevent contact with the backpaint. 3. Mirrors are mounted using stainless steel screws with protective collars through pre-cleaned, dry holes to prevent contact between the mirror and hard materials. A 3-5mm gap is maintained for ventilation, especially for wet areas. Larger mirrors use top and bottom supports for safety.

Uploaded by

mudassir2640
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Installation Procedure

Preparation
Be sure mirror are inspected after processing:
-To clean mirror with water and dry immediately after edge processing, especially around
mirror edges.
-Check the backpaint condition if there is any scratch of peel off around mirror edge
especially after edge processing, make sure the mirror used for the installation is clean
and dry, especially on the back paint and mirror edges.
Surface Preparation
-Wall surface must be cleaned and dry, never installed on new plaster, newly cured cement
or newly painted wall.
-If there is possibility that wall surface would have wet condition,
Apply water proofing layer on surface
-Poly plywood is commonly use as mounting surface, please noted that ;
Poly plywood need to be in dry condition-Oven pre heated plywood is preferable.
If poly plywood is attached to the wall using nail, after nailing, nail head must be
sealed using neutral sealant (to avoid direct contact with mirror back paint).

Mounting

3.1 Mounting using screw method


-Make sure the hole in the mirror are clean and dry. It should not have any scratch or
peel off of back paint, especially around the hole edge.
-Please use stainless steel screw with synthetic protection collar to attach the mirror to
mounting surface.The screw must not directly contact with mirror. In general, avoid any
contact between the mirror and hard material.
-Always maintain a gap of about 3-5mm between glass and mounting surface to allow good
ventilation. This is mainly recomended for fixing in very wet premises such as bathrooms,
fitness rooms, etc.
-Mirror size of 2sqm or more, for safety reason, recommended to use top & bottom support
(ie. U shape, etc.)

You might also like