L7 Introduction To Light
L7 Introduction To Light
L7 Introduction To Light
In the beginning of this unit on Light, we will not concern ourselves with what light is
(particle, wave or something else), rather we will begin by working with the observable
properties of light.
I. Sources of light
There are two basic ways that we see light:
1. We see light that is emitted from a source of some kind (i.e. light bulb, Sun, stars,
television, etc.). Note that the eye receives only a small part of the light emitted
from the source.
light source
eye ball
2. We also see light that is reflected from an object of some kind (i.e. pencil, paper,
etc.). Note that the eye receives only a small part of the light reflected by the
object.
object
7-1 01/10/2010
1.
If a metre stick casts a shadow that is 1.5 m long and a tree’s shadow at the same time
is 18 m long, how tall is the tree?
2.
If a pin hole camera is used to photograph a 1.5 m tall boy located 10 m from the
camera and the camera is 0.10 m long, what is the size of the image formed on the
film? What is the orientation of the image?
For a discussion of pin hole cameras, see pages 473 and 474 in the text.
camera boy
image
1.5 m
x
0.10 m 10 m
The similar triangles involve the boy (large) and the image (small).
x = 1.5 m
0.10 m 10 m
Note that of the millions of rays which pass from the boy into the camera, it is only the
ones from the bottom and the top of the object that are required to define where and
what size the image will be.
7-2 01/10/2010
III. The speed of light
Galileo tried to measure the speed of light by measuring the time required for light to
travel a known distance between two hilltops. He had an assistant stand on one hilltop
and himself on the other and ordered the assistant to lift the shutter on his lantern when
he saw a flash from Galileo’s lantern. Galileo intended to measure the time between
the flash and when he received the signal back from the assistant. The time was so
short that Galileo realised that the reaction time was far greater than the actual time for
the light to move across the distance. He concluded that the speed of light was
extremely high.
The first successful determination of the speed of light began with an observation by
the Danish astronomer Ole Roemer (1644-1710). Roemer noted that the period of one
of Jupiter’s moons (Io) varied slightly depending on the relative motion of the Earth and
Jupiter. When the Earth was moving away from Jupiter the period was slightly longer,
and when Earth moved toward Jupiter the period was slightly shorter. The Dutch
scientist Christian Huygens (1629-1695) was intrigued by Roemer’s result. Huygens
reasoned that if they measured when Io appeared from behind Jupiter for different
positions of the Earth relative to Jupiter, there should be a time difference.
Earth furthest
from Jupiter Earth closest
to Jupiter Jupiter
Io’s
orbit
Distance difference =
2 x radius of Earth
orbit
When the Earth was furthest away from Jupiter Io should appear later than expected.
Their measurements confirmed that this was indeed the case and the calculation
dis tan ce difference
speed of light =
time difference
yielded a result that the speed of light was very fast.
Since then a number of techniques have been used to measure the speed of light.
Among the most important were those carried out by Alberta A. Michelson (1852-1931).
Michelson used a rotating mirror apparatus diagrammed below for a series of high-
precision experiments carried out from 1880 to the 1920’s. Light from a source was
directed at one face of a rotating eight-sided mirror. The reflected light travelled to a
stationary mirror a large distance away and back again as shown. As the light travelled
away and back, the eight-sided mirror rotated. If the rotating mirror was turning at just
the right rate the returning beam of light would reflect from one of the mirror faces into a
small telescope through which the observer looked. In this manner, the rotating mirror
acted as a time piece. By knowing the frequency of rotation and the two way distance
travelled by the light, one can calculate a very accurate value for the speed of light.
7-3 01/10/2010
observer
Stationary
reflecting mirror
Rotating
eight-sided
mirror
light source
35 km
7-4 01/10/2010
IV. Practice problems
1. The flame of a candle is 30 cm above a table. A 10 cm tall glue stick container is
standing 35 cm from the candle. How long is the shadow of the glue stick?
(17.5 cm)
7-5 01/10/2010
3. Olaf Roemer noticed that the time when one of Jupiter’s moons was eclipsed by
the planet changed depending on the season in which the measurement was
taken. When the Earth was closest to Jupiter compared to when the Earth was
furthest away from Jupiter (on the other side of the Sun), there was a 1320 s
difference. Roemer correctly interpreted this observation to be the effect of the
increased distance that light had to travel to reach the Earth. If the Earth’s mean
radius of orbit is 1.5 x 1011 m, what is the speed of light that Roemer measured?
(2.3 x 108 m/s)
4. Using the Michelson apparatus diagrammed below, the observer found that in
order to observe the return light ray, the mirror had to rotate at 533.3
rotations/second. What is the speed of light calculated from this experiment?
(2.99 x 108 m/s)
observer
Stationary
reflecting mirror
Rotating
eight-sided
mirror
light source
35 km
7-6 01/10/2010
V. Hand-in assignment
1. In communicating with an automatic space station, radio signals travelling at the
speed of light must travel a distance of 8.7 x 109 m each way. How long does it
take for a radio signal to travel to the station and back? (58 s)
2. A light-year is the distance light travels in one year. How far (in metres) does light
travel in three years? (2.84 x 1016 m)
4. Our nearest neighbour among the stars (except for our own sun) is Proxima
Centauri which is 4.3 light-years away.
A. How far is this star away in kilometres? (4.07 x 1013 km)
B. How long does it take for light to reach us from this star? (4.3 years)
C. Our fastest space craft at the present time could have speeds approaching
3.0 x 105 m/s. How long would it take for such a spacecraft to reach
Proxima Centauri? (~4300 years)
D. How long would it take for the spaceship that went to the moon (maximum
speed 10 km/s)? (~1.3 x 105 years)
5. If the Earth's radius of orbit around the sun is 1.49 x 1011 m, how long does it take
for sunlight to reach the Earth? (497 s)
6. If Galileo and his assistant were 4.7 km apart, how long would it take for light to
traverse the distance? (1.57 x 10-5 s)
7. The respective radii of the Earth's and Jupiter's orbits are 1.49 x 1011 m and
7.78 x 1011 m. The difference in transit times of IO, between when the planets are
closest and furthest apart is 1.00 x 103 s using modern instruments. Calculate the
speed of light using these measurements. (2.98 x 108 m/s)
8. Calculate the distance from the pinhole to an object that is 3.5 m high and whose
image is 10 cm high in the pinhole camera which is 20 cm long. (7.0 m)
9. Calculate the height of a building 300 m away from a pinhole camera that
produces a 3.0 cm high image in a pinhole camera that is 5.0 cm long. (1.8 x 102
m)
10. A pin hole source of light shines on a card that is 5.0 cm tall located 25 cm from
the light source. What is the size of shadow formed on the wall 75 cm behind the
card? (20 cm)
*11. A coin with a diameter of 2.0 cm is illuminated from a centred point source of light
5.0 cm away. What is the area of the shadow on a screen 20 cm from the light
source? (50.2 cm2)
7-7 01/10/2010
12. A street lamp is 10.0 m tall and is situated 15 m from a 1.0 m high fence. How
long will the fence's shadow be? (1.7 m)
13. In a Michelson method to measure the speed of light a six-sided rotating mirror
assembly was used. The minimum frequency of rotation for a successful reading
was 54.15 rotations/second. If the reflecting mirror was 450 km from the rotating
mirror, calculate the speed of light. (2.92 x 108 m/s)
14. What is the approximate frequency in Hertz for an eight-sided Michelson's rotating
mirror in order to produce a successful experiment when the fixed mirror is 51.52
km away? (364 Hz)
15. When verifying the speed of light, a student set up a pentagonal rotating mirror
and a reflecting mirror 35 km away. At what minimum frequency must the mirror
rotate so that the reflected light is seen by the observer? (857 Hz)
7-8 01/10/2010