Cat 6 UTP PVC Cable

Belden 7965E
Construction
Conductor 23 awg solid bare copper (0.57mm)
Insulation Polyolefine
Pair 4 twisted pairs: white/blue & blue, white/orange & orange, white/green & green,
white/brown & brown Conductor identification according to IEC 60304
Diameter over insulation 1.01mm
Cross web FRNC compound
Sheath Flame retardant PVC, grey
Overall diameter: 6.20mm

BATT Part Number 54248

Applications
Horizontal & building backbone cable to support cat 6 and cat 5e applications, such
as 10 Base-T, 100 Base-T, 1000 Base-T, FDDI, ATM

Standards
ISO/IEC 11801 2nd edition (2002), EN 50173 2nd edition (2001), ANSI/TIA/EIA
568-b.2 (2002)

General Characteristics
Temperature range - operation -200C to +600C
Temperature range - installation 00C to +500C
Minimum bending radius - operation 25 mm
Minimum bending radius - installation 50mm
Maxiumum pulling tension 80N
Flame retardancy IEC 60332
Caloric value 490 kJ/m
Weight 43.9 kg/km
Maximum operating voltage 48 V rms
Max continuous current per conductor (250C) 1.4 A

Electrical Characteristics at 200C

Nominal mutual capacitance at 1kHz 50 nF/km
Max conductor DCR 70 Ohm/km
Nominal Velocity of Propagation 0.7 c
Mean characteristic impedance 4-100 MHz* 100 +/- 5 Ohms
SKEW - propagation delay difference (100MHz) typical ≤ 15 ns/100m

* according to cable requirements of ISO/IEC 11801 category 6, sept 2002

www.batt.co.uk
[email protected]
 Cat 6 UTP PVC Cable
Belden 7965E
Electrical Characteristics at 200C (cont)
Attenuation
Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Max)* dB/100m - 4.0 6.0 7.6 8.5 10.8 15.5 19.9 25.3 29.2 33
Typical dB/100m (1.7) 3.5 5.6 7.1 8.0 10.1 14.4 18.6 23.6 27.0 30.7

NEXT Near end crosstalk

Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 66 60 57 56 53 48 45 42 41 39

Typical dB/100m (76) 73 66 64 63 56 55 52 49 48 45

Power sum NEXT

Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 63 57 54 53 50 45 42 39 38 36

Typical dB/100m (74) 71 64 62 61 54 53 50 47 46 43

Power sum ELFEXT

Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 53 45 41 39 35 29 25 21 19 17

Typical dB/100m (70) 64 57 51 49 45 39 35 31 29 27

ACR
Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 62.0 54.0 49.4 47.5 42.2 32.5 25.1 16.7 11.8 6.0
Typical dB/100m (74) 70 60 57 55 46 41 33 25 21 14

Power sum ACR

Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 59.0 51.0 46.4 44.5 39.2 29.5 22.1 13.7 8.8 3.0
Typical dB/100m (72) 68 58 55 53 44 39 31 23 19 12

Return Loss
Frequency MHz 1 4 10 16 20 31.2 62.5 100 155 200 250

Spec (Min)* dB/100m - 23.0 25.0 25.0 25.0 23.6 21.5 20.1 18.8 18.0 17.3
Typical dB/100m (33) 36 44 42 40 38 36 31 27 25 24
* specification values according to cable requirements of ISO/IEC 11801 category 6, Sept 2002
Note: values between brackets are for information only
Aberdeen: 01224 897979 Leeds: 0113 253 3565 Germany: +49 6131 6273874

Birmingham: 0121 313 2870 Manchester: 01204 793111 Italy: +39 02 8965 6318

Bristol: 0117 966 6333 Peterborough: 01733 558485 Netherlands: +31 186 622311

Cardiff: 02920 450044 Teesside: 01642 678633 Singapore: +65 6515 9348

Edinburgh: 0131 333 4400 Belgium: +32 15 20 65 72 Houston: +1 713 590 1100

Erith: 01322 441165 Denmark: +45 3965 6650