Introduction of ALK-3
Introduction of ALK-3
894
April 17, 2002
Dear Sirs,
We would like to introduce an optional function that can transmit patient data and
measurement data obtained by Aloka diagnostic ultrasound system to a personal
computer. This function is referred to as ALK-3 data communication.
The transmitted data can be managed by the personal computer. This will reduce the
operator’s task of retyping measurement values on the PC, increase the accuracy of
data input, and eventually contribute to time-saving. Management of patient data will
become much easier with this function.
Note: Please note that other models including SSD-1700 are not and will not be
compatible to ALK-3 data communication.
-2-
(3) Personal computer with appropriate software installed and a cable to connect
Cable:
Type: RS-232C
Wire connection: strait
Connector for the isolation unit side: male DB-25
Connector for the PC side: a connector that fits to the RS-232C port of the PC
(female DB-9 or male DB-25, which depends on the PC)
Personal computer:
The PC needs software that enables ALK-3 data communication. Please
purchase commercially available software at your side. We would like to name
some companies that can sell software that enables ALK-3 data communication
as attached. If you desire your original software, please make your local
software company develop such software independently.
Please note that the usable PC and its environment depend on the software.
For detailed information, please contact the software company.
Software companies:
Please refer to in the attached papers for the addresses of the corporations.
At present we can introduce the four companies. In the near future, we would
like to add other companies in this list when verification of the software is
completed.
K. Kobayashi
Managing Director & General Manager
International Sales and Marketing Dept.
KK/Ss
Encl. List of software companies, List of parameters (measurements)