CCNA Questions

Download as txt, pdf, or txt
Download as txt, pdf, or txt
You are on page 1of 2

1. Which technology supports the stateless assignment of IPv6 addresses?

autoconfiguration

2. What are two requirements for an HSRP group? (Choose two.)


exactly one active router
exactly one standby active router

3. After you configure the Loopback0 interface, which command can you enter to
verify the status of the interface and determine whether fast switching is enabled?
Router#show ip interface loopback 0

4. Which command sequence can you enter to create VLAN 20 and assign it to an
interface on a switch?
Switch(config)#vlan 20
Switch(config)#Interface gig x/y
Switch(config-if)#switchport access vlan 20

5. Which three commands can you use to set a router boot image? (Choose three.)
Router(config)# boot system flash c4500-p-mz.121-20.bin
Router(config)# boot system tftp c7300-js-mz.122-33.SB8a.bin
Router(config)#boot system rom c7301-advipservicesk9-mz.124-24.T4.bin

6. Which two statements about IPv6 and routing protocols are true? (Choose two.)
Link-local addresses are used to form routing adjacencies
OSPFv3 was developed to support IPv6 routing

7. If primary and secondary root switches with priority 16384 both experience
catastrophic losses, which tertiary switch can take over?
a switch with priority 20480

8. Which two statements about late collisions are true? (Choose two.)
They may indicate a duplex mismatch
By definition, they occur after the 512th bit of the frame has been transmitted

9. Which command can you enter to set the default route for all traffic to an
interface?
router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1

10. Which two spanning-tree port states does RSTP combine to allow faster
convergence? (Choose two.)
blocking
listening

11. If a router has four interfaces and each interface is connected to four
switches, how many broadcast domains are present on the router?
4

12. The left describes the types of cables, while the right describes the purposes
of the cables. Drag the items on the left to the proper locations. (Not all items
can be used.) (THE COMMUNITY SHARED THAT THERE IS ANOTHER OPTION SO STUDY ALL OF
WHAT THIS CABLES ARE FOR)
switch access port to router > straight-throught
switch to switch > crossover
PC COM to switch console port > rollover

13. Match the items on the left with appropriate OSI layer on the right. (Not all
options are used.)
Network Layer: packet, IP Address, routing
Transport Layer: UDP, segments, windowing
14. Which command enables IPv6 forwarding on a Cisco router?
ipv6 unicast-routing

15. Refer to the exhibit. What is the most appropriate summarization for these
routes?
10.0.0.0 /22

http://fotoston.net/

You might also like