Introduction To Cardiovascular Physiology
Introduction To Cardiovascular Physiology
Introduction To Cardiovascular Physiology
Physiology
Sam Dudley, MD, PhD
Office: VA room 2A167
Tel: 404-329-4626
Email: [email protected]
Overview of the CV system
• Purposes
– Distribute metabolites and O2
– Collect wastes and CO2
– Thermoregulation
– Hormone distribution
• Components
– Heart – the driving force
– Arteries – distribution channels
– Veins - collection channels
– Capillaries – exchange points
Anatomy of the vasculature
Parallel and series design
• A given volume of blood
passes through a single
organ
• Blood entering an organ
RA LA has uniform composition
RV LV • Perfusion pressure is the
same for each organ
Organ 1 • Blood flow to each organ
Organ 2 can be controlled
independently
Organ 3
Relationships among the vascular beds
• Flow is constant in each segment, so velocity and area are inversely related
• Pressure loss occurs mainly at the small arterioles, the resistance vessels
• The veins contain most of the blood
Properties of arteries
• Elastic arteries • Muscular arteries
– Consists of the Aorta – Most of the named
and its large branches arteries
– Fairly distensible – Contain increased
because of high elastin
content smooth muscle
– Diastolic elastic recoil – Large lumen-to-wall
provides potential ratio
energy for flow when
the heart is not
contracting
Properties of the microcirculation
• Consists of arterioles, • Capillaries
capillaries, and – Exchange point
venules between blood and
• Arterioles interstitial fluid
– Reduced lumen-to-wall – Mechanisms of
ratio exchange include:
– Controlling point for • Diffusion
flow • Bulk flow
– Convert pulsatile to • Vesicular transport
steady flow
Equations of exchange
• Diffusion is described by:
dc
Q = DA
dx
where Q is flow, A is area, D is the diffusion coefficient, and dc/dx is
the concentration gradient. D incorporates such constants as solubility,
temperature, and molecular size.
• Bulk flow is described by the Starling equation:
Q = k (∆P − ∆π )
where Q is the flow of water, ∆P is the hydrostatic pressure difference,
∆π is the osmotic pressure difference, and k is the hydrostatic
permitivity constant.
Veins and lymphatics
• Veins
– Thin-walled, smaller amounts of smooth muscle or
elastin
– Slow flow, large cross-sectional area
– Acts a conduits and reservoirs
– Venoconstriction raises ventricular filling, cardiac
output
• Lymphatics
– Drains the interstitium
• Only route for of returning interstitial proteins
– Low flow (~2L/day)
Cardiac anatomy
K+ Na+ Ca2+
SARCOLEMMA
ATP ATP
Ca2+
SARCOPLASMIC
RyR2 Ca2+ Ca2+ RyR2 RETICULUM
ATP
Ca2+
SARCOMERE
• Ca2+ enters from sacrolemmal Ca2+ channels, diffuses to the SR Ca2+ release
channel (ryanodine receptor), and causes a large Ca2+ release.
• SR Ca2+ release raises intracellular Ca2+ from 10-7 M to 10-5 M, enough to
cause Ca2+ binding to troponin, displacing tropomyosin, causing actin-myosin
cross bridge cycling
The sliding filament hypothesis
Sliding filaments 2
Length-tension (Frank-Starling Effect)
• Length of a fiber
determines force
generation
• The major determinate
of length in the heart is
chamber volume
• The ascending limb
results from length-
dependent changes in
EC coupling
• The descending limb
derives mostly from the
number of thick and
thin filament cross
bridge interactions
Pressure-volume loops
• Determinants of cardiac
output (stroke volume x
heart rate)
– Preload or ventricular end
diastolic volume
– Afterload or Aortic pressure
– Contractility or modulation
of active force generation
(ESPVR, inotropy)
– Ventricular compliance
(EDPVR, lusitropy)
ESV= end systolic volume;
– Heart rate EDV = end-diastolic volume;
SV = stroke volume
PV loop in heart failure
Myocardial work
• Most myocardial work is potential work
W = ∫ PdV
• Myocardial O2 consumption is a function of myocardial
wall tension, contractility, and heart rate
• The law of Laplace:
T = Pr/ 2
where T is tension, P is pressure, and r is the radius.
– Larger ventricles have higher wall tension and O2 utilization to
produce the same pressure as smaller ones
The cardiac cycle
• Systole
– Phase 1: atrial contraction
– Phase 2: Isovolumetric
contraction
• Interval between
ventricular systole and
semilunar valve opening
– Phases 3 & 4: rapid and
reduced ejection (55-60%)
• Diastole
– Phase 5: Isovolumetric
relaxation
• Begins with closure of the
semilunar valves
– Phase 6: Rapid filling
• Opening of the AV valves
– Phase 7:Diastasis
Hemodynamics