8.3.1.4 Packet Tracer - Implementing A Subnetted IPv6 Addressing Scheme - ILM EG
8.3.1.4 Packet Tracer - Implementing A Subnetted IPv6 Addressing Scheme - ILM EG
Scheme
Topology
Addressing Table
Link-
Local
Device Interface IPv6 Address
R1
G0/1 2001:DB8:ACAD:00C9::1/64 FE80::1
R2
G0/1 2001:DB8:ACAD:00CB::1/64 FE80::2
Part 2: Configure the IPv6 Addressing on Routers and PCs and Verify Connectivity
Scenario
Your network administrator wants you to assign five /64 IPv6 subnets to the network shown in the topology.
Your job is to determine the IPv6 subnets, assign IPv6 addresses to the routers, and set the PCs to
automatically receive IPv6 addressing. Your final step is to verify connectivity between IPv6 hosts.
Subnet Table
Part 2: Configure the IPv6 Addressing on Routers and PCs and Verify
Connectivity
Step 1: Configure the routers with IPv6 addressing.
Note: This network is already configured with some IPv6 commands that are covered in a later course. At this
point in your studies, you only need to know how to configure IPv6 address on an interface.
Configure the four PCs for autoconfiguration. Each should then automatically receive full IPv6 addresses from
the routers.
Part 1 Total 60 60