Scribd
Upload
597 views3 pages

RENAULT Immobilizer Emulator EML921/203 Installation Guide

This document provides an installation guide for an EML921/203 Renault immobilizer emulator. It includes: 1) Technical specifications for the EML921/203 emulator including supported voltage, immobilizer system, and wiring connections to the ECU. 2) Instructions for installing the emulator inside popular ECU models from Bosch including cutting traces, connecting power and ground wires, and modifying EEPROM data. 3) Diagrams showing how to connect the emulator inside the ECU and cut the immobilizer wire from the connector.

Uploaded by

Anonymous OFfJVrQY6
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
597 views3 pages

RENAULT Immobilizer Emulator EML921/203 Installation Guide

This document provides an installation guide for an EML921/203 Renault immobilizer emulator. It includes: 1) Technical specifications for the EML921/203 emulator including supported voltage, immobilizer system, and wiring connections to the ECU. 2) Instructions for installing the emulator inside popular ECU models from Bosch including cutting traces, connecting power and ground wires, and modifying EEPROM data. 3) Diagrams showing how to connect the emulator inside the ECU and cut the immobilizer wire from the connector.

Uploaded by

Anonymous OFfJVrQY6
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

RENAULT immobilizer emulator EML921/203 installation guide

2015.04.01 edition 01

EML921/20.3 technical data:


EML 921
Supply voltage: 10-15V (DC)
Renault immo
ID:20.3 Supported immo system: immo 2 via one wire
+12V K-Line
GND
Wiring description:

[+12V] - power supply after ignition switch (Terminal 15)

LED indicator
[K-Line] - Data wire, connected to ECU .

[GND] - Ground.

[!] Before installation emulator, ECU must be in NEW state (previous immobilizer code must be cleared)

LED indicator after ignition “on”:

LED still off No power supply, broken emulator


LED slowly flash Normal condition
LED go on and still light. Data line short to ground or not connected to ECU

Examples must popular ECU’s:

Bosch MSA15.5 (1.9 dti)

EEPROM (24C02) location

Write changes in eeprom as


shown in example (red with
green border)

[!] before making changes,


compare original data:
data in first green window
(adr.: 0x03E – 0x041) must be
equal with second green
window (adr.: 0x054 – 0x057),
see second example

Original data example


Emulator installation inside ECU:

Cut trace as shown in photo


->

Emulator GND and Power


supply connect to power
2
diode, using 1-1.5 mm
copper wire.
Data line connect with thin
flexible wire to resistor as
shown
in photo ->

Bosch EDC 15 (1.9 dci)

Read eeprom(95080), all


black area (from 0x170 to
0x27F) change to 00h and
write eeprom.
Emulator installation inside ECU:

Connect emulator as shown in


photo ->

In some cases this component


not present. Connect immo
wire to empty place.

Cut immo wire: connector A,


pin G2. In photo marked with
green ->

You might also like