0% found this document useful (0 votes)
385 views1 page

Fiberstrong Wavistrong: Flange Guide

The document provides guidelines for bolt torques for flange joints using prescribed torque values in two tables. Table 1 lists bolt torques for gaskets with rubber and steel materials. Table 2 lists bolt torques for flange joints using O-ring seals. The bolt torques apply to specific pressure ratings and pipe diameters. Bolt torques for configurations other than what is recommended may differ and require case-by-case review.

Uploaded by

siva8000
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
385 views1 page

Fiberstrong Wavistrong: Flange Guide

The document provides guidelines for bolt torques for flange joints using prescribed torque values in two tables. Table 1 lists bolt torques for gaskets with rubber and steel materials. Table 2 lists bolt torques for flange joints using O-ring seals. The bolt torques apply to specific pressure ratings and pipe diameters. Bolt torques for configurations other than what is recommended may differ and require case-by-case review.

Uploaded by

siva8000
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FIBERSTRONG

WAVISTRONG
Flange Guide

8. Bolt torques
The bolts of flange joints shall be tightened using the prescribed bolt torques, which are given in tables 1 and 2.
These torque values are applicable for ASA 150, ASA 300 and PN 10 to PN 63 drilling patterns in combination with the
recommended sealing material as specified in chapter 4.

Bolt torques for other drilling patterns (API/JIS/ASA 600/etc) or for gaskets, other than recommended by FPI, including
special gaskets on valves, pumps, etc, might differ from the values given in tables 1 and 2. Recommended bolt torque
values for these applications shall be reviewed on a case-by-case basis by the FPI Technical Support team.

Table 1. Bolt torques for gaskets

Torque (Nm)
Rubber gaskets with steel inlay
Kroll & Ziller G-ST-P/K(N) & G-ST-P/S and Kempchen WG2
ID PN ≤ 12.5 PN 16 - 20 PN 25 - 32 PN 40 - 50
(mm) (bar) (bar) (bar) (bar)
25 10 10
40 - 65 15 15
80 - 125 25 25
150 - 200 35 50 50
250 - 300 50 50 75 100
350 - 500 75 90 125 150
600 - 700 100 200 300 300
750 - 800 200 300 300 400
900 - 1400 300 400 550

Table 2. Bolt torques for “O-ring” seal

Torque (Nm)
ID PN ≤ 12.5 PN 16 - 25 PN 25 - 32
(mm) (bar) (bar) (bar)
1500 - 1800 100 200 300
1900 - 4000 100

10 Fiberstrong & Wavistrong Flange Guide

You might also like