h14963 Unity Hybrid Family DC Ss
h14963 Unity Hybrid Family DC Ss
h14963 Unity Hybrid Family DC Ss
Physical Specifications
300 400 500 600
Min/Max Drives 5/150 5/250 5/500 5/1000
Array Enclosure There are 2 versions: A 2U Disk Processor Enclosure (DPE) with twenty five 2.5” drives and a 2U Disk Processor
Enclosure with twelve 3.5” drives.
Drive Enclosure (DAE - All models support 2U twenty five drive trays for 2.5” drives, 3U fifteen drive trays for 3.5” drives, and 3U eighty drive
Disk Array Enclosure) trays for 2.5” drives
Dell EMC Unity systems are powered by 2 power supplies (PS) per DPE/DAE. Each power supply can provide
Standby Power System power to the entire module if the peer PS has been removed or is faulted. DPE power during a power failure is
provided by a Battery Back Up (BBU) module. BBU is located within the SP enclosure and provides power to a
single module (power zone)
CPU per Array 2 x Intel 6-core, 1.6GHz 2 x Intel 8-core, 2.4GHz 2 x Intel 10-core, 2.6GHz 2 x Intel 12-core, 2.5GHz
Embedded 10GbaseT
Ports per Array 4 4 4 4
4 ports: 8/16 Gb FC**, 4 ports: 8/16 Gb FC**, 4 ports: 8/16 Gb FC**, 4 ports: 8/16 Gb FC**,
Embedded CNA ports per
10Gb IP/iSCSI, or 1Gb 10Gb IP/iSCSI, or 1Gb 10Gb IP/iSCSI, or 1Gb 10Gb IP/iSCSI, or 1Gb
Array
RJ45 RJ45 RJ45 RJ45
1 GbaseT/iSCSI Max
Total Ports per Array 24 24 24 24
Max Raw Capacity*** 2.34 PBs 3.9 PBs 7.8 PBs 9.7 PBs
Formatted
536.7 536.7 1100.5 1650.8 1834.3 3668.6 5505.0
Capacity (GB)
Supported in 15
drive DAE and 12 √ √ √ √ √ √ √
drive DPE
Supported in 25
√ √ √ √ no no no
drive DAE/DPE
Rotational Speed 15,000 rpm 10,000 rpm 10,000 rpm 10,000 rpm 7,200 rpm 7,200 rpm 7,200 rpm
Interface 12 Gb SAS
Average Write 3.1 msec 4.2 msec 4.2 msec 4.2 msec 9.5 msec 9.5 msec 9.5 msec
Rotation Latency 2.0 msec 3.0 msec 3.0 msec 3.0 msec 4.16 msec 4.16 msec 4.16 msec
NOMINAL POWER CONSUMPTION (WATTS)
Operating Mode 7.8 5.6 5.6 5.6 12.2 12.2 12.2
Virtualization Solutions
Dell EMC Unity offers support for a wide variety of protocol and advanced features available via various software suites
and packs including but not limited to:
Dell EMC Storage Integrator (ESI): For provisioning within the Microsoft management context (Systems Center) for
Hyper-V and SharePoint
OpenStack Cinder Driver: For provisioning and managing block volumes within an OpenStack environment
OpenStack Manila Driver: For managing shared file systems within an OpenStack environment
Dell EMC Virtual Storage Integrator (VSI) for VMware vSphere™ : For provisioning, management, and cloning
VMware Site Recovery Manager (SRM) Integration: Managing failover and failback making disaster recovery rapid
and reliable
Virtualization API Integration: VMware: VAAI and VASA. Hyper-V: Offloaded Data Transfer (ODX) and Offload Copy
for File
In-rush Current 40 A peak, per requirement in EN300 132-2 Sect. 4.7 limit curve
DIMENSIONS
Weight kgs/lbs empty empty empty empty empty empty empty empty
26.60/58.51 24.60/54.11 26.60/58.51 24.60/54.11 26.60/58.51 24.60/54.11 26.60/58.51 24.60/54.11
Vertical size 2 NEMA 2 NEMA 2 NEMA 2 NEMA 2 NEMA 2 NEMA 2 NEMA 2 NEMA
units units units units units units units units
Height cm/inches 8.88/3.5 8.88/3.5 8.88/3.5 8.88/3.5 8.88/3.5 8.88/3.5 8.88/3.5 8.88/3.5
Width cm/inches 44.76/17.62 44.76/17.62 44.76/17.62 44.76/17.62 44.76/17.62 44.76/17.62 44.76/17.62 44.76/17.62
Depth cm/inches 68.43/26.94 60.9/24.0 68.43/26.94 60.9/24.0 68.43/26.94 60.9/24.0 68.43/26.94 60.9/24.0
Note: Power consumption values for DPEs and DAEs are based on fully populated enclosures (power supplies, drives and I/O modules).
Ride-through Time 5 ms min (test conditions: Vin = -40VDC) 1 ms min at -50 V input
Continuous Allowable Range Operation Data center economization techniques (e.g. 10°C to 35°C (50°F to 95°F) at 20% to 80%
free cooling) may be employed to improve relative humidity with 21°C (69.8°F) maximum
overall data center efficiency. These dew point (maximum wet bulb temperature).
techniques may cause equipment inlet De-rate maximum allowable dry bulb
conditions to fall outside the recommended temperature at 1°C per 300m above 950m
range but still within the continuously allowable (1°F per 547 ft above 3117 ft).
range. Equipment may be operated without
any hourly limitations in this range.
Expanded Allowable Range Operation During certain times of the day or year, 5°C to 10°C and 35°C to 40°C (with no direct
equipment inlet conditions may fall outside the sunlight on the equipment) at -12°C dew point
continuously allowable range but still within the and 8% to 85% relative humidity with 24°C
expanded improbable range. Equipment dew point (maximum wet bulb temperature).
operation is limited to ≤ 10% of annual Outside the continuously allowable range
operating hours in this range. (10°C to 35°C), the system can operate down
to 5°C or up to 40°C for a maximum of 10% of
Statement of Compliance
This Information Technology Equipment is compliant with the electromagnetic compatibility (EMC) and product safety
regulations/standards required by the countries in which the product is sold. EMC compliance is based on FCC part 15,
CISPR22/CISPR24 and EN55022/EN55024 standards, including applicable international variations. EMC compliant
Class A products are marketed for use in business, industrial, and commercial environments. Product Safety
compliance is based on IEC 60950-1 and EN60950-1 standards, including applicable national deviations. DC products
comply with NEBS Level 3 and ETSI requirements and are tested to the following standards: GR-63-CORE, GR-1089-
CORE & ETSI EN 300 386, EN 300 132-2, EN 300 753, EN 300 019
The individual devices used in this product are approved under a unique regulatory model identifier that is affixed to
each individual device rating label, which may differ from any marketing or product family name in this data sheet.
For additional information see https://support.emc.com, under the Safety & EMI Compliance Information tab.
Dell EMC believes the information in this document is accurate as of its publication date. The information is subject to
change without notice.