Scribd
Upload
214 views2 pages

SSD Fresh Water Generators

Wartsila Fresh Water Generators

Uploaded by

Vitmann
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
214 views2 pages

SSD Fresh Water Generators

Wartsila Fresh Water Generators

Uploaded by

Vitmann
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Waste & Fresh Water Management

WÄRTSILÄ SERCK COMO SINGLE STAGE


DESALINATION (SSD) FRESH WATER GENERATORS


Wärtsilä has developed an energy The Wärtsilä Serck Como Single The technology is simple and has
efficient and cost-effective technology Stage Desalination (SSD) fresh water a modular design. The automated
for seawater desalination, with a generator uses the process of vacuum operation and low maintenance
capacity up to 35 t/d, for marine and distillation to remove the salt and other requirements enable continuous and
offshore applications. impurities from seawater and convert it user friendly handling.
into high quality, drinkable fresh water.
SYSTEM BENEFITS Thanks to the low seawater flow the
• Low electrical consumption Wärtsilä Serck Como SSD consumes a
• Low carbon footprint due to reduced amount of electricity.
optimized weight The system uses a vacuum
• Easy operation distillation process that enables the use
• Control panel included with of low temperature heat. The generator
automated system utilises the waste heat from the main
diesel engine or other alternative heat
sources to evaporate the seawater.
DIMENSIONS & TECHNICAL DATA

Length Width Height Weight


Model
(mm) (mm) (mm) (kg)

Size 1 970 960 1680 580 - 620


Size 2 1260 960 1680 610 - 660

The weights given for the fresh water generators are in an empty condition. An additional
10% should be assumed for their operational weight. The weight and dimensions include the
control panel.

SCHEMATIC DIAGRAM WORKING PRINCIPLE


• After passing the condenser section the
Sea water seawater will flow through the air-brine ejector.
• A small part of the seawater flow is used as
Non condensable gases feed water to the evaporation section.
Distillate
• Through a suction process the air-brine
ejector removes the excessive feed water as
well as the air from inside the casing.
• After a maximum of 5 minutes a vacuum of
Demister
Heating water approx 90% is reached.
• The evaporation of the feed water starts
immediately.
Feed water
• The vapour flows through the demister and
will be condensed in the condenser section.
• The distillate is pumped out of the unit.

Brine

Ejector

Brine

SCOPE OF SUPPLY Heating


• Casing with cover in stainless steel. Water
• Condenser and evaporator plates in titanium.
• Demister in stainless steel.
• Distillate pump in stainless steel with electrical motor. 70°C Size 1
• Combined air and brine ejector.
• Chemical dosing tank including the dosing instrument.
• Control panel with motor starters, built-in salinometer and 80°C Size 1 Size 2
common alarm.
• Complete documentation and drawings.
90°C Size 1 Size 2
OPTIONAL EQUIPMENT
• Seawater pump including electrical motor.
5 10 15 20 25 30 35
• Mineralization filter for adjusting the pH-value of the distillate.
Capacity in t/day
• Fresh water disinfection unit for disinfection of the distillate before
drinking.
• Counter flanges - from DIN flanges to ANSI and JIS. The capacity range shown above is based on 32° C seawater temperature.
• Pre-heater.
Printed 04/2014 CA

WÄRTSILÄ® is a registered trademark. Copyright © 2014 Wärtsilä Corporation.


Specifications are subject to change without prior notice.

[email protected]

WARTSILA.COM

You might also like