Scribd
Upload
526 views2 pages

96 Rotary Encoder Hn38-06-n

The document describes an optical rotary encoder with 400 pulses per revolution. It has AB two-phase quadrature output, works with a supply voltage of 5-24V DC, and has a maximum speed of 6300 revolutions per minute. It is used to measure rotation speed, angle, acceleration and length.

Uploaded by

amplificadordiferenc
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
526 views2 pages

96 Rotary Encoder Hn38-06-n

The document describes an optical rotary encoder with 400 pulses per revolution. It has AB two-phase quadrature output, works with a supply voltage of 5-24V DC, and has a maximum speed of 6300 revolutions per minute. It is used to measure rotation speed, angle, acceleration and length.

Uploaded by

amplificadordiferenc
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

OPTICAL ROTARY ENCODER 400 PULSE

Model: HN3806-AB -400N

Features:
-AB two-phase, pulse signal generation count can be identified by the rotation direction of the grating disk and
optocoupler.
-Performance: 400 Pulse per Revolution
-DC5-24V wide supply voltage
-Maximum mechanical speed: 6300 rev/min
-Dimensions: -The encoder body size: φ38mm;
-Shaft: φ6 × 16mm;
-Axis platform: high 5mm, φ20mm;
-Fixing hole: M3 screws,
-Three mounting holes on the circle 30 and the other three mounting holes in the 28th round;
side of the outlet.

Electronics Katrangi Trading

www.ekt2.com
Output:
AB two-phase quadrature output rectangular pulse, the circuit output is NPN open collector output type, the
output of this type can with internal pull-up resistor be directly connected to the microcontroller or PLC, such as
51 single or Mitsubishi PLC (the PLC input should switch to the 0V work). Note: if the encoder is not connected
to the device it cannot be directly connected to oscilloscope (open collector output when there is no pull-up
resistor, there is no voltage output), to connect to oscilloscope add two pull-up resistor AB two-phase output.

Application:
Used to measure the rotation speed of the object, angle, acceleration and length measurements.
Suitable for all kinds of intelligent control displacement measurement, automatic fixed-length leather guillotine
machines, steel cutting length controller, human height scale, students racing robots.

Connection:
-Red: VCC
-Black: GND (0V)
-White: Phase A
-Green: Phase B
Note: AB two-phase output must not be directly connected to VCC, otherwise, they will burn the output
transistor.

Made in China

Electronics Katrangi Trading

www.ekt2.com

You might also like