Mechanics 2
Mechanics 2
Mechanics 2
𝑽
𝝉=
𝑨𝒗
AV
ILLUSTRATIVE PROBLEMS 1.3 3. As shown in the figure below, a
hole is to be punched out of a
1. The lap joint shown in the figure plate having a shearing strength
below is fastened by four rivets of of 40 ksi. The compressive stress in
3/4-in. diameter. Find the the punch is limited to 50 ksi.
maximum load P by shearing of a. Compute the maximum
thickness of plate in which
rivets in pound-force that can be
a hole 2.5 inches in
applied if the working stresses are diameter can be
14 ksi for shear in the rivet and 18 punched. Ans: t=0.781 in.
ksi for bearing in the plate. b. If the plate is 0.25 inch
Assume that the applied load is thick, determine the
distributed evenly among the diameter of the smallest
four rivets, and neglect friction hole that can be
punched. Ans: d=0.8 in.
between the plates. Ans: P = 24
700 lb
PLATE NO. 2
1. The lap joint is connected by three 20-mm-diameter rivets. Assuming that the
axial load P ¼ 50 kN is distributed equally among the three rivets, find (a) the
shear stress in a rivet; and (b) the maximum average net tensile stress in each
plate. Ans: (a) 53.1 MPa; (b) 18.18 MPa
2. A key prevents relative rotation between the shaft and the pulley. If the torque T
¼ 2200 N_m is applied to the shaft, determine the smallest safe dimension b if the
working shear stress for the key is 60 MPa. Ans: 17.46 mm