HydroElite StayInControl en
HydroElite StayInControl en
HydroElite StayInControl en
stay in control
HydroeliteTM
HydroeliteTM is an integrated control and drive system
for hydraulic elevators. This means that no separate
control unit is required. All the decentralised functions
in the system communicate via a common data bus.
This gives simple interfaces and increased flexibility
with regard to the surrounding systems. By that
qualifications to appreciable reduced installation time
is given! HydroeliteTM is also available for machine-
roomless elevators.
Remote supervision
TM
The Hydroelite system contains supervision of the
elevator and can transmit error indications and service
diagnostics via the telephone/GSM network, which can
be distributed via the Internet. Options such as an
emergency telephone are available.
Everyone gains
At both new installation and modernisation, the user
has the advantages of shorter waiting times, shorter
travelling times and considerably improved travel
comfort. For the property owner the advantage is
primarily lower energy use and greater reliability. The
elevator company profits on the reduced installation
time and the reduced requirements for training, and
also the simple order handling by our B2B-system.
Facts in brief
§ 10-50% shorter travel time by elimination of creeping time
§ 20-40% less installed motor power
§ 30-50% lower energy requirements
§ Possibility of 50% greater down speed
§ Greater traffic capacity without the need for oil cooling
§ Improved travel comfort
§ More rapid start, and travel not dependent on temperature or load thanks to “smart” electronics
§ Exact landing installation by means of self-learning positioning system
§ Built-in diagnostic system for effective maintenance and simple troubleshooting
§ Flexible and modular to suit all types of buildings
§ Remote-controlled fault reporting and service diagnostics
§ Direct control, down or full collective and also duplex
§ Up to 16 floors and 16 doors (2 entrances)
§ Reduced installation time thanks to flexible construction
§ System tested from the factory
TM
Technical description Hydroelite
Pump unit
A specially formed high-tech servo valve acts as an actuator for
precise oil flow control. The system is completely self-learning
and has no manual settings. The valve system is intended for
speeds of up to 1 m/s.
Control system
The control system consists of decentralised functions which
communicate via a data bus.
The control node, which is situated on the pump unit carries out
the following functions:
§ Main switch with motor protection
§ Control of the servo valve
§ Soft starter for the motor Control node
§ Communication to the car and to the floors
§ 4 x 20 character digital display with push buttons for
commissioning and diagnostics
§ Traffic control
Available as options are for instance:
§ Emergency telephone, either fixed telephone or GSM telephone
§ Web interface for supervision via intranet or Internet
The car node and the floor nodes manage all occurring inputs
and outputs and relay them to the control node via the data bus.
Position encoder
Car node
An absolute encoder which is connected to the car gives
continual information to the control system of the position and
speed of the elevator.
HydroeliteTM travel times
Use as required. The reduced time is not only positive for the
passengers. It is also decisive for energy saving because of the
shorter engaging time of the motor. Further energy saving is
received thanks to reduced up speed with maintained total
travelling time.
Higher traffic capacity Lower power consumption and smaller fuses / cable area