Scribd
Upload
245 views9 pages

Cell Selection & Reslection

The document discusses LTE to LTE intra-frequency measurement and cell reselection criteria. It states that the UE may not perform intra-frequency measurement if the serving cell's SrxLev and Squal values are above thresholds S_IntraSearchP and S_IntraSearchQ. It will perform measurement and reselect cells if these values fall below the thresholds. It also discusses criteria for reselection from LTE to 3G networks based on signal level and quality thresholds.

Uploaded by

Vishal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
245 views9 pages

Cell Selection & Reslection

The document discusses LTE to LTE intra-frequency measurement and cell reselection criteria. It states that the UE may not perform intra-frequency measurement if the serving cell's SrxLev and Squal values are above thresholds S_IntraSearchP and S_IntraSearchQ. It will perform measurement and reselect cells if these values fall below the thresholds. It also discusses criteria for reselection from LTE to 3G networks based on signal level and quality thresholds.

Uploaded by

Vishal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 9

Srxlev = Qrxlevmeas - (qrxlevmin + qRxLevMinOffset)- [max (pMaxOwnCEll - PUMAX,0)]

Squal = Qqualmeas - (qQualMinR9 + qQualMinOffsetR9)

< LTE to LTE Intra Frequency Measurement >

If the serving cell's evaluation result is as follows, UE may not perform intra frequency
measurement.
SrxLev > S_IntraSearchP
Squal > S_IntraSearchQ

Note : If neither of S_IntraSearchP nor S_IntraSearchQ is specified, UE applies the


default value (S_IntraSearchP = Infinity, S_IntraSearchQ = 0 based on 36.331)

If the serving cell's evaluation result does NOT meet following criteria, UE perform intra
frequency measurement.
SrxLev > S_IntraSearchP
Squal > S_IntraSearchQ

Note : If neither of S_IntraSearchP nor S_IntraSearchQ is specified, UE applies the


default value (S_IntraSearchP = Infinity, S_IntraSearchQ = 0 based on 36.331)

Both condition should fullfill

***As per current setting of S_IntraSearchP in db=44 & S_IntraSearchQ=9 , UE will remain
- PUMAX,0)]

Srxlev
Source 13
Nghbr 39

Rs Rn
-108 -103

S_IntraSearchP in db
start scanning neighbours & reselect based on ranking 44
Latch on same server

earchQ=9 , UE will remain on that cell till Rxlev reaches to -79 & Rxqual to -10 , then after will resl
Qrxlevmeas qrxlevmin qRxLevMinOffset
pMaxOwnCEll-- dbmPUMAX
-111 -124 0 23 23
-85 -124 0 23 23

qHyst qOffset
3 18

S_IntraSearchQ
9

o -10 , then after will reslect neighbour based on ranking.


Squal Qqualmeas qQualMinR9 qQualMinOffsetR9
10 -9 -19 0
16 -3 -19 0
Srxlev of the serving cell < sNonIntraSearch (SIB3),

Srxlev of LTE cell (serving cell) < threshServingLow (SIB3),

Srxlev of WCDMA cell > threshXLowP (SIB6),

3G Rxlevel

***As per current setting of 4G to 3G will start scanning if 4G level is -113 or Qoal is -16 or
***As per current setting of 4G to 3G will start reselct at level of -115 & above in 4G & targ
aSearch (SIB3),

Afetr satisfying this Measurement will start for 3G

Reselection will start :--


reshServingLow (SIB3), 4G

now will check for 3G level to allow


3G

Band
Srxlev = Qrxlevmeas- qRxLevMin - Pcompensation (for all cells) 2100

G to 3G will start scanning if 4G level is -113 or Qoal is -16 or worst


G to 3G will start reselct at level of -115 & above in 4G & target 3G cell level should be better than -
sNonIntraSearchPR9 sNonIntraSearchQR9
Latch on LTE 12 4
Latch on LTE

tReselEutr--sec ThreshSrvLow
Remain on LTE 1 10

threshLow
Remain on LTE 10

Qrxlevmeas qRxlevMin Pcompensation Srxlev


-117 -115 0 -2

should be better than -105


The UE has to always perform measurements on LTE frequencies with higher priority than the serving WCDMA cell.

Cell reselection to a higher priority LTE frequency is performed by the UE if Srxlev of the LTE cell is greater than threshHigh f

Only LTE cells fulfilling the S-criteria, that is cells with Srxlev> 0, are considered as candidates for cell reselection. If more than o
the highest Srxlev level among the cells meeting the criteria on the highest absolute priority layer

When the LTE Cell Reselection for Advanced LTE Deployments feature is enabled, the new alternative cell resele
§  Cell reselection to a higher priority LTE frequency is performed by the UE if the RSRQ in LTE cell is above a mi
EutranFreqRelation.threshHigh2 for a duration of treSelection seconds.

****As per current setting reselection from 3G to 4G based on level will be at -111 of 4G fo
****As per current setting reselection from 3G to 4G based on quality will be at -9 of 4G fo
treSelection--sec threshHigh
Reselect LTE 1 12

EutranFreqRelation.qQualM
in +
treSelection--sec
EutranFreqRelation.threshH
igh2
Reselect LTE 1 -9

You might also like