Scribd
Upload
33 views1 page

Name: Ahmad Ibrahim Almasri ID: 106393 Section: 1

This experiment aims to study how to use analog input and output pins in applications. It will use a seven segment display connected to an Arduino UNO to display the numbers 0 to 9 when different pushbuttons are pressed. The pushbuttons act as switches that connect a circuit when pressed, and pull-up/pull-down resistors are used to set the default state of the input pins.

Uploaded by

Ahmad Almasri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views1 page

Name: Ahmad Ibrahim Almasri ID: 106393 Section: 1

This experiment aims to study how to use analog input and output pins in applications. It will use a seven segment display connected to an Arduino UNO to display the numbers 0 to 9 when different pushbuttons are pressed. The pushbuttons act as switches that connect a circuit when pressed, and pull-up/pull-down resistors are used to set the default state of the input pins.

Uploaded by

Ahmad Almasri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Name: Ahmad Ibrahim Almasri ID: 106393 Section: 1

Experiment #2 (Digital Inputs / Outputs)

Objectives:
- Studying how to employ analog input and output pins to useful in applications.
- Using common digital output devices consist of numbers of LEDs.
- Knowing common types of switches.
- Knowing how switches are working.

Equipment and Tools:


- Arduino UNO.
- Bread Board.
- Seven segment display.
- Swathes such as Pushbutton.
- Resistances.
- Wires.

Experiment:
We will use “Seven Segment Display” to show the numbers from 0 to 9. Where “Seven Segment
Display” consist of 10 pins two from them are ground.
For the switches:
- we will use the pushbutton which is a component that connects two points in a circuit when you
press it.
- All digital inputs use the pull-up and pull-down resistor to set the default state of the input pins.

You might also like