Scribd
Upload
51 views7 pages

15 WEEKS - Submission On 7 - 15 May 2018: Mini Project

This document outlines the requirements for a 15-week mini project involving monitoring process variables like level, temperature, pressure, and flow rate using inexpensive materials. Students must: 1. Select sensors to monitor the variables and develop a process description with a flow diagram. 2. Design a piping and instrumentation diagram using software that includes a controller, sensors, and data logger to monitor the process. The controller must use an Arduino circuit and recycled materials must be used where possible with a maximum cost of RM 250. 3. Submit the project on time with a receipt showing costs were under budget or marks will be deducted, and dates must be followed or marks will be reduced by 40%.

Uploaded by

AmandaEdwin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views7 pages

15 WEEKS - Submission On 7 - 15 May 2018: Mini Project

This document outlines the requirements for a 15-week mini project involving monitoring process variables like level, temperature, pressure, and flow rate using inexpensive materials. Students must: 1. Select sensors to monitor the variables and develop a process description with a flow diagram. 2. Design a piping and instrumentation diagram using software that includes a controller, sensors, and data logger to monitor the process. The controller must use an Arduino circuit and recycled materials must be used where possible with a maximum cost of RM 250. 3. Submit the project on time with a receipt showing costs were under budget or marks will be deducted, and dates must be followed or marks will be reduced by 40%.

Uploaded by

AmandaEdwin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Mini Project

15 WEEKS – Submission on 7th – 15th May 2018


Introduction

 You need to :
1. Select instrument of monitoring of process variables that available in industry as
example level, temperature, pressure and flow rate -( 5 marks)
2. A complete process description in pdf format with process flow diagram. –(10 marks)
3. Using any Piping Instrumentation Diagram freeware such PI & D Designer or else draw
comprehensive with these elements:
1. Final control element: such as solenoid valve, heater or relevant mechanism
2. Controller – arduinno circuit as microcontroller 45 marks
3. Sensor work as Measure variables example thermocouple
4. Data logger or recovery such ba
Continue…
4. Use recycle material such can, used pvc pipes and cheaps material.
5. Estimate the cost not more than RM 250.00 with controller and final control
element. 30 marks
6. Compress air source can be used at lab instrument wire diameter of
reinforced tubing (ɸ) diameter of 25mm

7. On time submission with:


 receipt of purchase as evidence cost control- fail to hand will cause 10 marks
deduction
 Follow date line. If fail then any given mark will be reduce to 40%
 https://learn.sparkfun.com/tutorials/sik-experiment-guide-for-arduino---
v32/experiment-7-reading-a-temperature-sensor
Microcontroller Real / Arduino tool
Example of Sensor
Model your system with using any
chemical equations…

You might also like