Scribd
Upload
23 views

Confined Strength Ratio F /F

Uploaded by

Ronal J Clavijo R
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
23 views

Confined Strength Ratio F /F

Uploaded by

Ronal J Clavijo R
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Confined Strength Ratio f^/f^

Downloaded from ascelibrary.org by Universidad Militar Nueva Granada on 02/04/16. Copyright ASCE. For personal use only; all rights reserved.

0.2 0.3
Smallest Confining Stress Ratio, f
</Uo
FIG. 4. Confined Strength Determination from Lateral Confining Stresses for
Rectangular Sections

fc = Ecec when fc < / , ' (30a)


otherwise
fc = 0 (30b)
where Ec = tangent modulus of elasticity of concrete given by Eq. 8; ec =
longitudinal tensile concrete strain; and/,' = tensile strength of concrete.

STRESS-STRAIN RELATION FOR CYCLIC LOADING AT SLOW STRAIN RATES

The monotonic loading stress-strain curve is assumed to form an


envelope to the cyclic loading stress-strain response. That is, the mono-
tonic curve is assumed to be the skeleton curve. This was found to be the
case in two studies by Sinha et al. (1964) and Karsan and Jirsa (1969) for
tests on unconfined (plain) concrete specimens. The test results for
confined concrete by Mander et al. (1984) shows that this assumption is
also reasonable for reinforced concrete specimens.

Unloading Branches
Unloading of the concrete may occur from either the compressive or
tensile portion of the skeleton stress-strain curve as follows:
Compression Unloading
Fig. 5 shows a stress-strain curve including an unloading branch. To
establish a reversal stress-strain curve from the compressive loading curve
given by Eq. 3, a plastic strain epl based on the coordinate at the reversal
point (e„„, /„„) on unloading needs to be determined. The procedure
1813

J. Struct. Eng., 1988, 114(8): 1804-1826

You might also like