Scribd
Upload
206 views3 pages

How To Program LTMR Relay For Proper Operation in VFD Applic

programming of schneider make LTMR relays

Uploaded by

Himesh Nair
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
206 views3 pages

How To Program LTMR Relay For Proper Operation in VFD Applic

programming of schneider make LTMR relays

Uploaded by

Himesh Nair
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
VFD Appl How to Program LTMR Relay for Proper Operation Directions to resolve fault light and reset issue on VFD Panels Load the custom file, “Rolls Royce iff into the LTMR located in the VFD panel. This custom file sets up input 16 to control the output 0.1, This change enables contol of the drive while in remote Auto mode. Please be sure the overioad behaves the way you want on a fault, conditions. To apply the logic file, do the following in Powersuite: 41. Connect the communication cable from your laptop to the overload relay (TeSys T LTMR), 2. Tum on lap top and run the Schneider Electric PowerSuite program. Launch LTM ‘configuration, 3. Click on Custom Logic to expand the directory. 4, Click on Structured Text. 5, Select Logic Functions (on top toolbar in between tools and settings) --> Open Logic File woe 6. Change the file type to logic files and open the Rolls Royce logic fle (see below) 7, Select Logic Functions ~> Compile 8 Select Logic Functions > Download Program to Device 9. After a successful download select Settings -> Motor Control (Sitesyst programmer 1.6.0.0 My conouter| [Birols Royce. MyRecent Jy Network Paces Decunents | yapplcaton Syctrrization [Gaur cash (Be Biorusemce Decne | feRCestom D5 Fes aeswe = (Gui tec B \@nro [Boroereer My Documents ye (@shintech 2 ¢ Barestea networks My Computer P Fle ns 10. Change the operating mode to custom and change the Custom ID to 256 as shown below. @ ae 11. Verify the settings have been accepted in the relay and then disconnect the communication cable. Repeat steps for the next VFD panel TeSys T LTR,

You might also like