Scribd
Upload
139 views15 pages

MAC Setting X3045

The document provides steps to set up Repetier-Host on a Mac for use with the CoLiDo X3045 3D printer. It describes downloading and installing Repetier-Host, creating a printer profile for the X3045, installing necessary drivers, importing an STL file, slicing it with Slic3r, connecting and starting a print.

Uploaded by

marcos lemos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
139 views15 pages

MAC Setting X3045

The document provides steps to set up Repetier-Host on a Mac for use with the CoLiDo X3045 3D printer. It describes downloading and installing Repetier-Host, creating a printer profile for the X3045, installing necessary drivers, importing an STL file, slicing it with Slic3r, connecting and starting a print.

Uploaded by

marcos lemos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 15

Repetier – Host setting for MAC

(X3045)

[email protected]
Install Repetier-Host to MAC

[email protected]
X3045 printer setting

Step1: Double chick the Mac OSX\Repetier-Host-Mac_0_56.dmg file


in the download folder.

[email protected]
X3045 printer setting

Step2: Click Repetier-Host Mac.app to open Repetier-Host. Then


click the “Printer setting” on the top right.

[email protected]
X3045 printer setting

Step3: Click on “add” to create “CoLiDo X3045 printer setting.

[email protected]
X3045 printer setting

Step4: Under the “connection” bar, to fill in information refer the


picture below:

[email protected]
X3045 printer setting

Step 5: Under the “Behaviour” bar, to fill in information refer the


picture below:

[email protected]
X3045 printer setting

Step 6: Under the “Dimension” bar, to fill in information refer the


picture below:

[email protected]
X3045 printer setting

Step 7: Replace the folder in the SD card Mac OSX\Slic3r to the


\Application support\Slic3r as pictures shown below：

[email protected]
X3045 printer setting

Step 8: Install the printer control board driver:

For Mac OX S 10.3 to 10.8 please install Mac


OXS\FTDIUSBSerialDriver_v2_2_18 inside the SD card；
For Mac OX S 10.9 and upper version Please install Mac
OXS\FTDIUSBSerialDriver_v2_3 inside the SD card

[email protected]
Repetier-Host setting

[email protected]
Repetier-Host setting

Step 1: Open Rpetier-Hose, Click on “Object Placement” tab, Click


“Add STL file” button. (Show as below)

[email protected]
Repetier-Host setting

Step 2: Select STL file

[email protected]
Repetier-Host setting

Step 3: Click on the "Slicer” submenu, Choose the setting you need
and click on “Slice with Slic3r” to slice.

[email protected]
Repetier-Host setting

Step 4: When slice object done, click “Connect” button on the top left
corner, When button turning into green then click “Run” to start print.

[email protected]

You might also like