Scribd
Upload
275 views1 page

EEE 5 Homework 01: Instructions

This document contains instructions for a homework assignment on electrical circuits. Students are asked to analyze circuits diagrams and answer 10 questions regarding the number of nodes, resistors in parallel and series, and calculating equivalent resistances and currents based on given resistance values. They are to show their work and box their final answers.

Uploaded by

Joseph Vladimir Estillore
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
275 views1 page

EEE 5 Homework 01: Instructions

This document contains instructions for a homework assignment on electrical circuits. Students are asked to analyze circuits diagrams and answer 10 questions regarding the number of nodes, resistors in parallel and series, and calculating equivalent resistances and currents based on given resistance values. They are to show their work and box their final answers.

Uploaded by

Joseph Vladimir Estillore
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EEE 5 Homework 01

Electrical and Electronics Engineering Institute


University of the Philippines Diliman
2nd Semester SY 2017 - 2018

Instructions:

Write your answers in one (1) whole yellow pad paper. Show your solutions and box your nal answers. Do not forget
to write the proper units. Use the gure on the left (above), right (above), and below to answer questions 1-3, 4-7, and
8-10 respectively.

A
R1

R3
R1
R2 R2 R3
R4 R4 R5

R2 R6
R2

RA =1Ω RB

+ +
+
12V − 10V RC 2V

− −

IX

Questions:

1. How many nodes are there in the circuit?

2. Is/are there any resistor/s in parallel with R1? If yes, list the resisor/s.

3. Is/are there any resistor/s in parallel with R2? If yes, list the resisor/s.

4. How many nodes are there in the circuit?

5. Is/are there any resistor/s in series with R3? If yes, list the resisor/s.

6. Is/are there any resistor/s in series with R4? If yes, list the resisor/s.

7. Suppose you are to simplify the resistor network into one single resistor across nodes A and B. What will be the
value of this equivalent resistance (again, across nodes A and B) given the folowing resistance values: R1=5 ohms,
R2 = 10 ohms, R3=6 ohms, R4 = 20 ohms, R5 = 15 ohms, R6 = 5 ohms. Hint: a short or a wire has 0 ohm
resistance.

8. Determine the value of the current IX.

9. What is the value of the resistance RC.

10. What is the value of the resistance RB.

You might also like