0% found this document useful (0 votes)
96 views3 pages

Discussions Questions From Lecture 2

The document contains discussion questions from lectures 2, 3 and 4 on transfer functions and mechanical systems. It includes questions about finding transfer functions from given differential equations and block diagrams of mechanical systems, as well as questions about basic elements and steps to obtain transfer functions for rotational and translational mechanical systems.

Uploaded by

ELIZABETH
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
96 views3 pages

Discussions Questions From Lecture 2

The document contains discussion questions from lectures 2, 3 and 4 on transfer functions and mechanical systems. It includes questions about finding transfer functions from given differential equations and block diagrams of mechanical systems, as well as questions about basic elements and steps to obtain transfer functions for rotational and translational mechanical systems.

Uploaded by

ELIZABETH
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

DISCUSSIONS QUESTIONS FROM LECTURE 2

2s+3
1. A system is characterized by the transfer function 𝐺(𝑠) = (𝑠+1)(𝑠+6) . Find out how the
system respond to an exponentially decaying input 𝑅(𝑡) = 𝑒 −2𝑡 .

2𝑠2 −5
2. Finding the inverse Laplace transform of 𝐹(𝑠) = (𝑠+1)(𝑠+2)

3. An impulse is applied at the input of the system and the output is observed to be the time
function 𝐶(𝑡) = 𝑒 −2𝑡 . Find the transfer function of this system.

4. A mechanical device used in a forge press operation has the following differential
𝜕2 𝑦 𝜕𝑦
equation of motion 16.3 𝜕𝑡2 + 87.5 𝜕𝑡 + 221𝑦 = 𝐹 .Determine the transfer function

5. Determine the transfer function of the controller, after application of 1 volt to the input of
the controller that is ec(t)= us(t). The output of controller is measured and described by
the following equation f(t)=100(1-0.3e-6t-0.7e-10t) us(t)
DISCUSSION QUESTIONS FROM LECTURE 3 and 4

1. Determine transfer function ɵ2/F of a rotational system

2. Write the differential force equations for the rotational mechanical system below. Find
the transfer function from your equation . Assume that the torque T(t) is the input and the
output is ɵ2

3. Write the differential force equations for the Translational mechanical system below.
Find the transfer function from your equation. Assume that the force F(t) is the input and
the output is X2
4. Study the Translational mechanical system shown in figure 1 and answer the questions
that follows (INDIVIDUAL ASSIGNMENT 2 TO BE SUBMITTED 22/12/2017)

i. Describe steps required to obtain transfer function


ii. Identify the Basic elements of a Translational Mechanical System

iii. Find the transfer function,

5. Find the transfer function for the network using nodal and mesh analysis

6.

You might also like