DAVIE Quick Reference Guide: Programming with DAVIE

Programming Unit Pumps and Injectors Programming PMCI-2/EAS-3

Download current PRS file for chassis

Login to DAVIE (Use Single Truck PRS File Download steps)
Select Engine System—PMCI-2 Unzip and Install PRS file
Select Programming (Use Unzipping and Installing Files steps)
Select Calibration Codes
Select either Pump Unit Codes or Login to DAVIE
Injector Codes Select Engine System—PMCI-2
Select Programming
Select the Pump Unit or Injector to Select Program Basic Software
change Follow the prompts to program
Use on-screen keyboard to
enter code
4 digit code for pump
Maintain proper battery voltage and DO
6 digit code for injector NOT allow DAVIE to power down or switch
vehicle off while programming controllers

Once PMCI-2 has been

programmed, it is required to
Verify new code entered is program the EAS-3
correct (in RED)
Select Aftertreatment—EAS-3
Once code is verified, Select Programming
click the Program button Select Program Basic Software
If Program button is not Follow prompts to program
selected, the injector or
pump will NOT be programmed. Reinitialize the EGR Valve and BPV after
performing BOTH controller updates.
Always verify programming after
completion
All information in this document is subject to change. Consult ePortal (DealerNet) to ensure all current procedures are being followed
Published by PACCAR Inc. This material is intended for PACCAR Inc training purposes and may not be sold, given, loaned or reproduced, in whole or in part, including photocopying, without the express
written consent of PACCAR Inc. 2012, PACCAR Inc Version 20120105
 DAVIE Quick Reference Guide: Programming with DAVIE

Programmable Customer Parameters Programming Change Request

Two types of programmable customer parameters exist; Login to ePortal (DealerNet)
The parameters value mentioned below can be Select Service tab
changed by using DAVIE in the Programming From Quick Links on the
section under Customer Parameters right, select SupportNet
A list of additional programmable parameters can be
found in the Engine Bulletin E007 and in the From SupportNet Home page, select Engine Support
PACCAR MX Programming Guide (located on Select Engine Software Change
DealerNet) Fill out all appropriate fields in the
Changes to PRS files can be made through change request
PACCAR Engine Pro or by request to the Engine document. When completed, click
Support Center. Submit Case
Cruise control
V-max 0-100 mph When request is processed, it will show up as a
Cruise V-max 12-105 mph completed case.
Cruise offset -5 to 5 mph
PTO Conditions
V-max PTO 0-50 mph
PTO disable 0-19 mph
PTO Engine Speed Download the zipped Single Truck PRS File
Min PTO speed 0-2000 rpm (You will be able to download the file from SupportNet and
Max PTO speed 0-2000 rpm do NOT need to download as a Single Truck PRS File)
PTO target 0-1000 rpm
Engine Speed Control
Park brake override (active/inactive)
Fan Clutch Controls Unzip and Install new PRS file
Fan activation PTO (enable/disable) (Use Unzipping and Install Files steps)
Tire Circumference Program chassis with new PRS file
Tire revs per mile 124-671 revs per mile (Use Programming PMCI-2/EAS-3 steps)
Note: BOTH controllers MUST be reprogrammed
All information in this document is subject to change. Consult ePortal (DealerNet) to ensure all current procedures are being followed
Published by PACCAR Inc. This material is intended for PACCAR Inc training purposes and may not be sold, given, loaned or reproduced, in whole or in part, including photocopying, without the express
written consent of PACCAR Inc. 2012, PACCAR Inc Version 20120105