Review of Antenna Geometries and Arrangements. Wireless vs. Cable Communication Systems. The Radio-Frequency Spectrum.)

Download as pdf or txt
Download as pdf or txt
You are on page 1of 15

LECTURE 1: Introduction into Antenna Studies

(Definition and circuit theory description. Brief historical notes. General


review of antenna geometries and arrangements. Wireless vs. cable
communication systems. The radio-frequency spectrum.)

1. Definition and circuit theory description.

The antenna (aerial, EM radiator) is a device, which radiates or


receives electromagnetic waves.

The antenna is the transition between a guiding device (transmission


line, waveguide) and free space (or another usually unbounded medium).
Its main purpose is to convert the energy of a guided wave into the energy
of a free-space wave (or vice versa) as efficiently as possible, while in the
same time the radiated power has a certain desired pattern of distribution
in space.

a) transmission-line Thevenin equivalent circuit of a radiating


(transmitting) system
Zg Rrad
IA

Vg Zc jX A
RL

Generator Transmission Antenna


Line
Vg - voltage-source generator (transmitter);
Zg - impedance of the generator (transmitter);
Rrad - radiation resistance (related to the radiated power
Prad = I A2 ⋅ Rrad
RL - loss resistance (related to conduction and dielectric losses);
jX A - antenna reactance.
Antenna impedance: Z A = ( Rrad + RL ) + jX A

1
One of the most important issues in the design of high-power
transmission systems is the matching of the antenna to the transmission
line (TL) and the generator. Matching is specified most often in terms of
VSWR. Standing waves are to be avoided because they can cause arching
or discharge in the TL. The resistive/dielectric losses are undesirable, too.
They decrease the efficiency factor of the antenna.

b) transmission-line Thevenin equivalent circuit of a receiving antenna


system
ZA
IA

ZL Zc VA

Receiver Transmission Antenna


Line

The antenna is a critical component in a wireless communication


system. A good design of the antenna can relax system requirements and
improve its overall performance.

2. Brief historical notes.


• James Clerk Maxwell formulates the
mathematical model of electromagnetism
(classical electro-dynamics), “A Treatise on
Electricity and Magnetism”, 1873. He shows
that light is an electromagnetic (EM) wave,
and that all EM waves (light included)
propagate through space with the same
speed, which depends on the dielectric and
the magnetic properties of the medium.

2
• Heinrich Rudolph Hertz demonstrates in 1886
the first wireless EM wave system: a λ / 2 -
dipole is excited with a spark; it radiates
predominantly at about λ ≈ 8 m; a spark
appears in the gap of a receiving loop. Hertz
discovers the photoelectric effect and predicts
that gravitation would also have a finite speed
of propagation. In 1890, he publishes his
memoirs on electrodynamics, simplifying the
form of the electromagnetic equations,
replacing all potentials by field strengths, and
deducing Ohm's, Kirchhoff's and Coulomb's
laws.
• May 7, 1895, the first wireless telegraph
message is successfully transmitted, received,
and deciphered. A brilliant Russian scientist,
Alexander Popov (also spelled Popoff,
Poppov), sends a message from a Russian
Navy ship 30 miles out in sea, all the way to
his lab in St. Petersburg, Russia. The Russian
Navy declares Popov's historical
accomplishment top secret. The title “Father
of Radio” goes to G. Marconi.
• Guglielmo Marconi (the Father of Radio) sends
signals over large distances. In 1901, he
performs the first transatlantic transmission
from Poldhu in Cornwall, England, to
Newfoundland, Canada. The receiving antenna
in Newfoundland was a 200-meter wire pulled
and supported by a kite. The transmitting
antenna in England consisted of 50 wires,
supported by two 60-meter wooden poles.
• The beginning of 20th century (until WW2) marks the boom in wire-
antenna technology (dipoles and loops) and in wireless technology as
a whole, which is largely due to the invention of the DeForest triode
tube, used as radio-frequency generator. Radio links are possible up
to UHF (about 500 MHz) and over thousands of kilometers.
3
• WW2 marks a new era in wireless communications and antenna
technology. The invention of new microwave generators (magnetron
and klystron) leads to the development of the microwave antennas
such as waveguide apertures, horns, reflectors, etc.

3. General review of antenna geometries and arrangements.


3.1. Single-element radiators.
A. Wire radiators (single-element)

wire antenna elements

straight-wire elements
loops helices
(dipoles/monopoles)

There is a variety of shapes corresponding to each group. For example,


loops can be circular, square, rhombic, etc. Wire antennas are simple to
make but their dimensions are commensurable with the wavelength. This
limits the frequency range of their applicability (at most 1-2 GHz). At low
frequencies, these antennas become increasingly large.

B. Aperture antennas (single element)

(a) Pyramidal horn

4
(b) Conical horn

or

(c) Open rectangular waveguide

Aperture antennas were developed before and during the WW2 together
with the emerging waveguide technology. Waveguide transmission lines
were primarily developed to transfer high-power microwave EM signals
(centimeter wavelengths), generated by powerful microwave sources such
as magnetrons and klystrons. These types of antennas are preferable in the
frequency range from 1 to 20 GHz.
5
C. Printed antennas

PRINTED PATCH RADIATORS

(a) Rectangular patch

(b) Circular patch

(c) Printed dipole

The patch antennas consist of a metallic patch etched on a dielectric


substrate, which has a grounded metallic plane at the opposite side. They
are developed in the beginning of 1970s. There is great variety of
geometries and ways of excitation.

6
PRINTED SLOT RADIATORS

7
Slot antennas were developed in the 1980s and there is still intensive
research related to new shapes and types of excitation. They are suited for
integration with slot-line circuits, which are usually designed to operate at
frequencies > 10 GHz.
Both patch and slot antennas share some common features. They are
easy and cheap to fabricate. They are easy to mount; they are light and
mechanically robust. They have low cross-polarization radiation. Their
directivity is not very high. They have relatively high conducting and
dielectric losses. These radiators are widely used in patch/slot arrays,
which are esp. convenient for use in spacecraft, satellites, missiles, cars and
other mobile applications.

D. Leaky-wave antennas

These are antennas derived from millimeter-wave (mm-wave) guides,


such as dielectric guides, microstrip lines, coplanar and slot lines. They are
developed for applications at frequencies > 30 GHz, infrared frequencies
included. Periodical discontinuities are introduced at the end of the guide
that lead to substantial radiation leakage (radiation from the dielectric
surface).

The antennas in the mm-wave band are of big variety and are still a subject
of intensive study.
8
E. Reflector antennas

A reflector is used to concentrate the EM energy in a focal point where


the receiver/feed is located. Optical astronomers have long known that a
parabolic cylinder mirror transforms rays from a line source on its focal
line into a bundle of parallel rays. Reflectors are usually parabolic
(paraboloidal). Actually, the first use of a parabolic (cylinder) reflector
was used for radio waves by Heinrich Hertz in 1888. Rarely, corner
reflectors are used. Reflector antennas have very high gain and directivity.
Typical applications: radio telescopes, satellite telecommunications. They
are not easy to fabricate and, in their conventional technology, they are
rather heavy. They are not mechanically robust.
The largest radio telescopes:
• Max Plank Institüt für Radioastronomie radio telescope,
Effelsberg (Germany), 100-m paraboloidal reflector;
• National Astronomy and Ionosphere Center (USA) radio telescope
in Arecibo (Puerto Rico), 1000-ft (304.8-m) spherical reflector;
• The Green Bank Telescope (the National Radio Astronomy
Observatory) – paraboloid of aperture 100 m.

9
TYPICAL REFLECTORS

F. Lens antennas
Lenses play a similar role to that of reflectors in reflector antennas.
They collimate divergent energy into more or less plane EM wave. Lenses
are often preferred to reflectors at higher frequencies (f > 100 GHz). They
are classified according to their shape and the material they are made of.

10
3.2. Antenna arrays
Antenna arrays consist of multiple (usually identical) radiating
elements. Arranging the radiating elements in arrays allows achieving
unique radiation characteristics, which cannot be obtained through a single
element. The careful choice and control of the phase shift and the
amplitude of the signal fed to each element allows the change of the
radiation pattern electronically, i.e. electronic scanning. Such arrays are
called phased arrays. The design and the analysis of antenna arrays is a
subject of its own, which is also related to signal processing. Intensive
research goes on nowadays, concerning smart antennas, signal-processing
antennas, tracking antennas, etc. Some commonly met arrays are shown in
the figure below.

11
4. Wireless vs. cable communication systems.
There are two broad categories of communication systems: those that
utilize transmission lines as interconnections (cable systems), and those
that use EM radiation with an antenna at both the transmitting and the
receiving end (wireless systems).
In areas of high density of population, the cable systems are
economically preferable, especially when broadband communication is in
place. Even for narrow-band communication, such as voice telephony and
low-data-rate digital transmission, it is much simpler and cheaper to build
wire networks with twisted-pair cables, when many users are to be
interconnected. Such lines introduce an attenuation of around 2-3 dB/km
at frequencies about 10 kHz. These lines are not suitable at higher
frequencies because of the higher losses and dispersion. At higher-
frequency carriers, carrying broadband signals (TV transmission and high-
data-rate digital transmission), coaxial cables are commonly used. The loss
is around 4-5 dB/km. The least distortion and losses are offered by the
12
optical-fiber transmission lines, which operate at three different
wavelengths: 850 nm (≅ 2.3 dB/km), 1300 nm (≅ 0.25 dB/km) and 1550
nm (≅ 0.25 dB/km). They are more expensive though and the respective
transmitting/receiving equipment is costly. Transmission lines provide a
measure of security and noise-suppression (coaxial, optical-fiber), but they
are not the best option in many cases (long distance, wide spreading over
large areas, low frequency dispersion).
A fundamental feature of all transmission lines is the exponential
increase of loss power. Thus, if the loss is 5 dB/km, then a 20-km line will
have 100 dB power loss (input power is reduced by a factor of 10-10), a 40-
km line will have a 200 dB power loss. This makes it rather obvious why
wireless systems are preferred for long-range communications, and in
scarcely populated areas. In most wireless channels, the radiated power
per unit area decreases as the inverse square of the distance r between the
transmitting and the receiving point. Doubling the distance r would
decrease the received power by a factor of 4 (or 6 dB will be added). Thus,
if a particular system has a 100 dB loss at r=20 km, doubling of its distance
will result in 106 dB loss (as compared to 200 dB loss in a cable system).
The comparison between the coaxial-line losses and free-space attenuation
at f=100 MHz is given in the figure below.

13
Modern personal mobile communications
services

• cordless telephony home environment


businesses – PABX (Private Automatic Branch
Exchange)
PHS (Personal Handyphone System) in Japan

• digital (and Northern America: PCS-1900 (Personal


analog) cellular Communication Services)
telephony Europe: GSM-900 (Global System for Mobile
Communications) and
DCS-1800 (Digital Communications Systems)

• mobile data packet-switched data transfer (MOBITEX,


transport DataTAC, etc.)
PCS two-way data communications; paging

• personal satellite INMARSAT, EUTELTRACS, Iridium, Globalstar


communications

• global navigation GPS, GLONASS, ODYSSEY


systems

Besides, there is a variety of special application of wireless technology in


• radar systems
• microwave relay links
• satellite systems (TV, telephony, military)
• radio astronomy
• biomedical engineering, etc.

14
5. The radio-frequency spectrum.

Table 1.1: General designation of frequency bands


Frequency band EM wavelength Designation Services
3-30 kHz 100-10 km Very Low Frequency Navigation, sonar♣, submarine
(VLF)

30-300 kHz 10-1 km Low Frequency (LF) Radio beacons, navigation

300-3000 kHz 1000-100 m Medium Frequency AM broadcast, maritime/ coast-


(MF) guard radio

3-30 MHz 100-10 m High Frequency Telephone, telegraph, fax; amateur


(HF) radio, ship-to-coast and ship-to-
aircraft communication

30-300 MHz 10-1 m Very High Frequency TV, FM broadcast, air traffic
(VHF) control, police, taxicab mobile radio

300-3000 MHz 100-10 cm Ultrahigh Frequency TV, satellite, radiosonde, radar


(UHF)

3-30 GHz 10-1 cm Super high Frequency Airborne radar, microwave links,
(SHF) satellite, land mobile
communication
30-300 GHz 10-1 mm Extremely High
Frequency (EHF) Radar, experimental

Table 2.1: Microwave-band designation


Frequency Old New
500-1000 MHz VHF C
1-2 GHz L D
2-3 GHz S E
3-4 GHz S F
4-6 GHz C G
6-8 GHz C H
8-10 GHz X I
10-12.4 GHz X J
12.4-18 GHz Ku J
18-20 GHz K J
20-26.5 GHz K K
26.5-40 GHz Ka K


Sonar (an acronym for Sound, Navigation and Ranging) is a system for underwater detection and location of objects
by acoustical echo. The first sonars, invented during World War I by British, American and French scientists, were used
to locate submarines and icebergs. Sonar is an American term dating from World War II.
15

You might also like