Scribd
Upload
318 views10 pages

Checkpoint 1180 Config

The document provides step-by-step instructions for initially configuring a firewall: 1) Set the computer's network adapter to DHCP, connect to the firewall's port 1, and access the firewall's admin interface. 2) Complete the initial configuration by setting settings like the device name, IP addresses, and admin password. 3) Review the network settings and additional routing can be added before contacting support for activation.

Uploaded by

ganesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
318 views10 pages

Checkpoint 1180 Config

The document provides step-by-step instructions for initially configuring a firewall: 1) Set the computer's network adapter to DHCP, connect to the firewall's port 1, and access the firewall's admin interface. 2) Complete the initial configuration by setting settings like the device name, IP addresses, and admin password. 3) Review the network settings and additional routing can be added before contacting support for activation.

Uploaded by

ganesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 10

1)Configure your computer network adapter to DHCP

2)Connect your computer to port 1 of the firewall

3)Open a browser and go to https://192.168.1.1:4434

4)The following screen will appear:

Click “Next”

5) Enter an Admin password at the next screen and click next


6) Set the time and date manually – we will configure NTP during integration
7)Enter the device name in the next screen- replace Bucharest with the appropriate office but keep the
corp-eu-xxxxx-fw01 syntax

Press next when complete

8) Select central management at the next screen and press next:


9) Enter your Internet IP address information:

Press next

The following screen will pop up:

Press “no” and continue


10) Enter the LAN IP address and disable DHCP and press nest

11) Configure Administrative access per below and press next:


12) Press next at license activation:

Press OK at the warning, we will activate the device during integration:


13) Configure the one time SIC password using C011iers$ press next

14) Select connect to management server later and press next:


15) Select finish:

16) You can confirm the network settings be reviewing them on the device tab:
17) Any additional internal networks can be added on the routing page:

18) We are done the initial configuration, once completed please contact [email protected],
to arrange a time for activation.

Also look through the device there is a lot of reporting included.

You might also like