Scribd
Upload
85 views1 page

TY Bistable Multi

The document describes the procedure for studying the working of a transistorized bistable multivibrator circuit. The circuit diagram and component values are given. The procedure involves identifying the initially on/off transistors, toggling the circuit by applying a 0V input, applying a square wave trigger input and observing waveforms at different frequencies to analyze the relationship between input and output frequencies.

Uploaded by

Neelam Kapoor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
85 views1 page

TY Bistable Multi

The document describes the procedure for studying the working of a transistorized bistable multivibrator circuit. The circuit diagram and component values are given. The procedure involves identifying the initially on/off transistors, toggling the circuit by applying a 0V input, applying a square wave trigger input and observing waveforms at different frequencies to analyze the relationship between input and output frequencies.

Uploaded by

Neelam Kapoor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

S.Y.B. Sc.

Bistable Multivibrator Group:

Aim : To study the working of transistorised Bistable multivibrator .

Apparatus: Given circuit, power supply ,Oscillator ,CRO.

Circuit diagram:

R1 = R4 =-------- , R2 = R3 = --------
R5 = R6 =------------- C1 = C2 = 0.0l uF

Procedure:
1.Draw the circuit diagram of the given Bistable Multivibrator configured as a divide by two
counter, using the steering diodes. Trace the circuit and write down the component values.
2 .Make necessary connections and identify which transistor is ON and which is OFF.
3. Study the toggling behavior of the circuit by applying 0 Volt input alternately at the base of
the ON transistor.
4 .Apply square wave trigger input. Study the waveforms at the input, at the base and collector
of both the transistors for three different trigger frequencies. Sketch all the waveforms on a
graph paper in all the three cases. Find the minimum trigger voltage for each input frequency.
5.Comment on the relation between input and output frequency.

Result:

You might also like