RFID Card Access Control System Manual - TimTec
RFID Card Access Control System Manual - TimTec
RFID Card Access Control System Manual - TimTec
RFID Card Capacity 250 cards, a “Personal PIN” goes alone with
6. Set Anti-Break Alarm:
each card
1) Disable anti-break alarm: press [4]+[0], 2 beeps;
4-digits public PIN Capacity 1234
2) Enable anti-break alarm: press [4]+[1], 2 beeps;
Proximity Reader Frequency 125KHz
3. Set door open mode: The customer should continuously type in 4 digits public PIN;
1) Card or Public PIN: the interval between each key pressing should be less than 2
Press [1]+[0], 2 beeps; seconds. If the interval is more than 2 seconds, the system will
2) Card plus Personal PIN; automatically quit this time’s PIN input.
3)If the customer entered the wrong PIN, press [*], and enter the 2、With access control power supply
right PIN again to open the lock.
Door To door contact The other end to GGND
2. Door opening mode of card + PIN DGND
1)Read authorized card, after a beep, Push/no To exit button The other end to DGND
(1) Enter the right 4 digits PIN (code) within 5 seconds, the NC To GND of the fail-safe lock The other end off the lock to
Wiring
1、With normal power supply
DGND
NC To GND of the fail-safe lock The other end off the lock to
+12VDC
GND To the GND of power supply